|Year: 1961/1962||Category: Broadcast Receiver - or past WW2 Tuner|
|Valves / Tubes||9: ECC85 ECH81 EF89 EF89 EM84 EABC80 ECC83 ECL86 ECL86|
|Wave bands||Broadcast, Long Wave, Short Wave plus FM or UHF.|
|Details||Record Player (perh.Changer)|
|Power type and voltage||Alternating Current supply (AC) / 110/220 Volt|
|from Radiomuseum.org||Model: Concerto 5296 WK - Telefunken Deutschland TFK,|
|Shape||Console, Lowboy (legs < 50 %).|
|Dimensions (WHD)||1400 x 800 x 400 mm / 55.1 x 31.5 x 15.7 inch|
|Notes||Pick-up / Turntable Telefunken 504.|
Model page created by Alain Dufour. See "Data change" for further contributors.
All listed radios etc. from Telefunken Deutschland (TFK), (Gesellschaft für drahtlose Telegraphie Telefunken mbH
Here you find 3293 models, 2832 with images and 1856 with schematics for wireless sets etc. In French: TSF for Télégraphie sans fil.
Hits: 619 Replies: 1telefunken: 5296 WK; Concerto
I have this console total beauty. I have replace all capacitors pluged in sounded beautiful ran for around 8 hours no issues then It blew the fuse. I replaced it and also found the wires that connect to the blubs where competely melted. I ran new wires and also found a cap that was connect there I couldn't see and also replaced it. I got everthing lighting up again put it back in the console it had low volume and a few minutes later the volume went out put still stay light up. I unplugged it went to pull the chassis out and wow the transformer was super hot. What should I do next I have never had a tranny get so hot before? this cannot benormal it also had a oil smell in the air.
any help suggestion?
Two main possibilities:
1) Something is still faulty taking too much current.
2) The previous fault overheated the transformer and insulation was damaged, creating a short internally.
Less likely, but check any voltage selector.
Disconnect all the secondary connections from the transformer. See then is it cool or merely warm when powered. If it gets really hot, too hot to touch, or smokes then it's now got an internal short on a winding. It will need rewound or replaced. If it's cool enough, then reconnect all the LT windings, but not HT.
First try with no valves or lamps. If still cool, insert them and check again, If it then is too hot look for a shorted bulb or valve or faulty socket.
If it's still cool, only slightly warm, not too hot to touch, reconnect the HT windings. If it then overheats examine the HT rectifier and then main smoothing electrolytic capacitor, or any noise suppression paper capacitors you might have missed.