Tube Tester I-177

MILITARY U.S. (different makers for same model)

Daten
Forum
Bilder
Sammlungen

  • Jahr
  • 1944
  • Kategorie
  • Service- oder Labor-Ausrüstung
  • Radiomuseum.org ID
  • 115467

Klicken Sie auf den Schaltplanausschnitt, um diesen kostenlos als Dokument anzufordern.

 Technische Daten

  • Anzahl Röhren
  • 2
  • Wellenbereiche
  • - ohne
  • Betriebsart / Volt
  • Wechselstromspeisung / 115 Volt
  • Lautsprecher
  • - - Kein Ausgang für Schallwiedergabe.
  • Material
  • Metallausführung
  • von Radiomuseum.org
  • Modell: Tube Tester I-177 - MILITARY U.S. different makers
  • Form
  • Tischmodell, Zusatz nicht bekannt - allgemein.
  • Abmessungen (BHT)
  • 5.7 x 15.5 x 8.5 inch / 145 x 394 x 216 mm
  • Bemerkung
  • This was the mutual conductance tube tester used by US Armed Forces since WWII.
  • Nettogewicht
  • 8 kg / 17 lb 9.9 oz (17.621 lb)
  • Datenherkunft
  • - - Manufacturers Literature
  Aggiornate il vostro Hickok I-177 2162 KB
  • Dokumente zu diesem Modell
  • Autor
  • Modellseite von Emilio Ciardiello angelegt. Siehe bei "Änderungsvorschlag" für weitere Mitarbeit.

 Sammlungen | Museen | Literatur

Sammlungen

Das Modell Tube Tester befindet sich in den Sammlungen folgender Mitglieder.

Literatur

Das Modell Tube Tester ist in der folgenden Literatur dokumentiert.

 Forum

Forumsbeiträge zum Modell: MILITARY U.S.: Tube Tester I-177

Threads: 1 | Posts: 10

Gentlemen,

I have recently purchased a Hickok I-177 tube tester with its expansion box. As the expansion box needed an intense recabling, I am now undergoing the process of adding other European-type sockets not originally present on the board while I’m on the task.
 
My concern is of course the fact that most European tubes are not listed in the data sheets. I see that a lot of work on this matter has been done by Nolan Lee (that’s why I was willing to <a href="http://www.radiomuseum.org/forum/any_news_about.html">get in contact with him</a>) and other fellows here and there on the net, but many tubes are not yet covered. Just to name one type: tubes with side-contact base.
 
Since the set up of the ammeter on the I-177 is very easy (one potentiometer only, the other one is fixed once the scale is set to MicroMhos) I was wondering if some of you fellows developed a general method to test tubes when the tube chart is given. Tube charts are easy to find on internet, so they’re no longer a problem.
 
What about comparing set-up values with the TV-7 model, which seem to have more literature? Is there some kind of conversion procedure to set the I-177 once the setup for the TV-7 is given?
 
Any comment on this subject is welcome.

Marco Gilardetti, 12.Jan.09

Weitere Posts (10) zu diesem Thema.