Salisbury Ch=33 Series 1

Pacific (Brand) Various manufacturers

Data
Forum
Pictures
Collections

  • Year
  • 1936
  • Category
  • Broadcast Receiver - or past WW2 Tuner
  • Radiomuseum.org ID
  • 334967

Click on the schematic thumbnail to request the schematic as a free document.

 Technical Specifications

  • Number of Tubes
  • 8
  • Main principle
  • Superhet with RF-stage; ZF/IF 456 kHz; 3 AF stage(s)
  • Tuned circuits
  • 9 AM circuit(s)
  • Wave bands
  • Broadcast plus 2 Short Wave bands.
  • Power type and voltage
  • Alternating Current supply (AC) / 225-250 Volt
  • Loudspeaker
  • Electro Magnetic Dynamic LS (moving-coil with field excitation coil) / Ø 10 inch = 25.4 cm
  • Material
  • Wooden case
  • from Radiomuseum.org
  • Model: Salisbury Ch=33 [Series 1] - Pacific Brand Various
  • Shape
  • Console with any shape - in general
  • Notes

  • Advertised as an “8-valve all wave bander, All-Wave Metal Valve Receiver”.

    Superhet with RF stage and 3 stages of IF amplification.

    Bands:  550 – 1500 kHz
                  2.8 – 8.4 MHz
                  7.8 – 22 MHz

    This 8-valve model has been designed to give maximum sensitivity and selectivity, using metal valves throughout. Improved selectivity with smooth automatic volume control is obtained by the use of two stages of intermediate frequency amplification.

    A sensitivity control, operating simultaneously with the manual volume control, assists in reducing interstation noise to a minimum. Half-wave diode detection is provided by a 6H6 valve, and a divided audio load circuit feeds the grid of a 6F5 high gain triode audio amplifier.

    The oscillator and screen grid circuits are stabilised with 8uF electrolytic condensers to avoid signal drift to variation of oscillator plate voltage, and to minimise audio-frequency distortion due to feed-back circuits.

    Individual coils are provided for the broadcast band, while dual short-wave coils occupy the second can for each stage.

    Chassis is also used in the Salisbury console version.

    See also the later chassis version, Series 2.

    Manufactured by Radio Corp NZ.

    John Stokes noted that the operating voltages in the Version 1 set were too high and added an additional 20k ohm resistor into the HT supply of the frequency changer.
    Notes from the late John Stokes dated May 1936. (Credit NZVRS).

  • Price in first year of sale
  • 42.50 NZ Pound
  • Mentioned in
  • -- Original prospect or advert (Franklin Times 14 Oct 1936 Page 2)
  • Literature/Schematics (1)
  • - - Manufacturers Literature (Service Bulletin No. 14)
  Service Bulletin No 14, 1st Edition May 1936 1331 KB
  • Documents regarding this model
  • Author
  • Model page created by Brian Stevens. See "Data change" for further contributors.

 Collections | Museums | Literature

 Forum