Electron Tube Curve Tracer 570

Tektronix; Portland, OR

  • Year
  • 1956 ?
  • Category
  • Service- or Lab Equipment
  • Radiomuseum.org ID
  • 116199

 Technical Specifications

  • Wave bands
  • - without
  • Power type and voltage
  • Alternating Current supply (AC) / 105-250 Volt
  • Loudspeaker
  • - For headphones or amp.
  • from Radiomuseum.org
  • Model: Electron Tube Curve Tracer 570 - Tektronix; Portland, OR
  • Dimensions (WHD)
  • 13 x 16.5 x 24.5 inch / 330 x 419 x 622 mm
  • Notes
  • Tektronix 570 Electron-Tube Characteristic Curve Tracer displays plate, screen or grid currents against plate or grid voltage. 4 to 12 steps per family. Accurate pointer voltmeter on the front panel to monitor dc and heater voltages. T52P1 CRT standard.
  • Net weight (2.2 lb = 1 kg)
  • 33.8 kg / 74 lb 7.2 oz (74.449 lb)
  • Price in first year of sale
  • 995.00 $
  • Mentioned in
  • - - Manufacturers Literature
  • Author
  • Model page created by Emilio Ciardiello. See "Data change" for further contributors.

 Collections | Museums | Literature

Collections

The model Electron Tube Curve Tracer is part of the collections of the following members.

 Forum

Forum contributions about this model: Tektronix; Portland,: Electron Tube Curve Tracer 570

Threads: 1 | Posts: 1

There is a tendency for some high Gm tubes being tested with the Type 570 Characteristic-Curve Tracer to oscillate despite the use of resistor patch cords and shielding with Belden braid.
Tektronix Field Engineer Earl Williams reports considerable sucess in suppressing these oscillation through the use of Ferramic cores installed on each bare-wire lead connecting pin jack to tube socket plug. Ferramic cores are the ferrite material beads that can be strung on wire to act as suppressors to high-frequency currents flowing in wire. Earl says that brief test did not show that use of beads could eliminate possible need for resistor patch cords, but he was able to display curves he had not seen to date.

Source: ServiceScope Oct 1959

 

Pius Steiner, 19.Jul.11

Weitere Posts (1) zu diesem Thema.