Stereo Amplifier SA-800

Pioneer Corporation; Tokyo

Daten
Forum
Bilder
Sammlungen

  • Jahr
  • 1971/1972
  • Kategorie
  • NF-(Niederfrequenz-) Verstärker oder -Mixer
  • Radiomuseum.org ID
  • 150853

 Technische Daten

  • Anzahl Transistoren
  • 35
  • Halbleiter
  • Hauptprinzip
  • NF-Verstärkung
  • Wellenbereiche
  • - ohne
  • Spezialitäten
  • Hi-Fi-Gerät
  • Betriebsart / Volt
  • Wechselstromspeisung / 120; 110/120/130/220/240 Volt
  • Lautsprecher
  • - Dieses Modell benötigt externe(n) Lautsprecher.
  • Belastbarkeit / Leistung
  • 68 W (165 W max./spitze)
  • Material
  • Gerät mit Holzgehäuse
  • von Radiomuseum.org
  • Modell: Stereo Amplifier SA-800 - Pioneer Corporation; Tokyo
  • Form
  • Regalgerät wie HiFi-Komponente für Bücherwand.
  • Abmessungen (BHT)
  • 430 x 145 x 337 mm / 16.9 x 5.7 x 13.3 inch
  • Bemerkung

  • A hi-fi stereo integrated amplifier housed in a wooden case with continuous power output of 2 x 34 watts into 8 ohms or 2 x 39 watts into 4 ohms. With wide power bandwidth. Power and preamplifier sections can be separated. Optional phono input transformer PP-402 required for MC cartridge. Terminals for 2 pairs of loudspeakers and centre channel terminal for connection to mono tape recorder.

    Stereo-Vollverstärker mit 2 x 39 Watt Sinus an 4 Ohm. 35 Transistoren, 2 FET's, 20 Dioden.

    Specification  
    POWER AMPLIFIER SECTION  
    Continuous Power Output
    (both channel driven)    		 39W + 39W into 4Ω
    34W + 34W into 8Ω
    Music Power Output (IHF) 165 Watts into 4Ω
    108 Watts into 8Ω
    Harmonic Distortion < 0.5% (Continuous power output)
    Intermodulation Distortion < 0.5% (Continuous power output)
    Power Bandwidth (IHF) 5Hz — 50kHz
    (8Ω, Harmonic Distortion <0.5%)
    Frequency Response 5Hz — 80kHz ±1dB
    Input Sensitivity/Impedance
    (1kHz, Continuous power output)    		 560mV/100kΩ
    Speakers 4 — 16Ω
    Damping Factor > 65 (8Ω, 1kHz)
    Center Channel Output 500mV
    PREAMPLIFIER SECTION  
    Output Voltage 3V (Rated output), 5V (Max.)
    Harmonic Distortion < 0.1%
    Frequency Response 20Hz — 60kHz ±1dB
    Input Sensitivity/Impedance
    (1kHz, for rated output)    		  
     PHONO 1. MAG 3mV/50kΩ
    CER 56mV/100kΩ
     PHONO 2. MM 3mV/50kΩ
    MC 110µV/30Ω (with PP-402)
     MIC
     TUNER
     AUX 1, 2
     TAPE MONITOR 1, 2    		 2.3mV/50kΩ
    230mV/200kΩ
    230mV/200kΩ
    230mV/200kΩ
    Recording Output  
     TAPE REC 1, 2 (Pin jack)
     TAPE REC (DIN connector)    		 230mV
    35mV
    Equalization Curve PHONO: RIAA
    LOW Filter
    HIGH Filter    		 -3.5dB/60Hz (12dB/oct.)
    -3dB/6kHz (12dB/oct.)
    Muting  -20dB
    Channel Separation (1kHz)  
     PHONO
     TUNER, AUX    		 > 50dB
    > 55dB

    Semiconductors:   35 Transistors, 2 FETs, 20 Diodes

    Versions/Power requirements
    KUW USA  /  120V AC 60Hz
    KCW Canada  /  120V AC 60Hz
    FVW General Export  /  110/120/130/220/240V AC 50/60Hz with voltage selector

    Power consumption:  230 watts max.

  • Nettogewicht
  • 10.3 kg / 22 lb 11 oz (22.687 lb)
  • Datenherkunft
  • -- Original prospect or advert
  • Literaturnachweis
  • - - Manufacturers Literature (1972 Pioneer Stereo Components catalogues)
  • Literatur/Schema (1)
  • - - Manufacturers Literature (Service manual Pioneer SA-800 dated 1971)
  • Literatur/Schema (2)
  • - - Manufacturers Literature (Operating Instructions Pioneer SA-800)
  • Autor
  • Modellseite von Franz Scharner angelegt. Siehe bei "Änderungsvorschlag" für weitere Mitarbeit.

 Sammlungen | Museen | Literatur

 Forum