Dynamic Range Enhancer 117

dbx Inc.; Waltham (MA)

  • Year
  • 1980 ?
  • Category
  • Miscellaneous (Other, Various) - see notes
  • Radiomuseum.org ID
  • 300343

Click on the schematic thumbnail to request the schematic as a free document.

 Technical Specifications

  • Number of Transistors
  • Semiconductors present.
  • Semiconductors
  • Main principle
  • Audio-Amplification
  • Wave bands
  • - without
  • Power type and voltage
  • Alternating Current supply (AC) / 115/240 Volt
  • Loudspeaker
  • - For headphones or amp.
  • Material
  • Metal case
  • from Radiomuseum.org
  • Model: Dynamic Range Enhancer 117 - dbx Inc.; Waltham MA
  • Shape
  • Book-shelf unit.
  • Dimensions (WHD)
  • 3 x 5 x 9 inch / 76 x 127 x 229 mm
  • Notes
  • Compression & expansion: continuous from 1.4 compression slope (14 dB output change/20 dB input change) to 2.0 expansion slope (20 dB output change/10 dB input change)
    Dynamic range: 120dB input or output
    Input noise: -110 dBm typical, -100 dBm maximum
    Input level: maximum input signal in excess of 30 Volts RMS
    Input impedance: 50K ohms
    Output level: maximum output 10 Volts RMS open circuit; +17 dBm into 600 ohms
    Output impedance: 500 ohms
    Distortion: 0.5% maximum @20 Hz, 0.2% typical above 50 Hz for complete cycle of compression and expansion; 1.2% @20 Hz for 2:1 expansion; .05% typical @ 1 KHz and above for any setting of controls (3 Volts RMS or less input or output.)
    Frequency response: +0, -1dB 20 Hz to 20 KHz
    Attack time: 50 dB/m Sec maximum initial attack rate @1.4 expansion. 12 mSec to 65% of final value @ any setting of compression or expansion. Adjusted to be within integrating time of human ear within the constraints of reasonable low frequency distortion.
    Release (decay) time: constant rate 140 dB/sec (norm) or 50 dB/sec (slow) @ 1.4 expansion
    Level match control: unity gain point may be varied from 100 mV to 1 Volt

    Power consumption:
    USA model 115 VAC 50-60 Hz 2 Watts
    EU model 240 VAC 50-60 Hz 2 Watts

    Power supply switched by shortening inputs on transformer.

  • Net weight (2.2 lb = 1 kg)
  • 4.5 lb (4 lb 8 oz) / 2.043 kg
  • Author
  • Model page created by Bartosz Szwed. See "Data change" for further contributors.

 Collections | Museums | Literature

Collections

The model Dynamic Range Enhancer is part of the collections of the following members.

 Forum