radiomuseum.org

P_Pliotron

Informazioni - Aiuto 
ID = 27663
       
Stato:
USA (Stati Uniti d'America)
Produttore: General Electric Co. (GE); Bridgeport CT, Syracuse NY
Progettista: General Electric Co. (GE); Bridgeport CT, Syracuse NY 
Tipo:  Triodo trasmittente, raffr. ad aria   Universal 
  <1925 rare
Identico a P_Pliotron = VT-10
Evoluzioni CG-916  

Zoccolo Pin-and-blade jumbo (3 contacts) Top contact with a cap.
Utilizzata per Transmittertube (Radio)
Filamento Vf 13 Volt / If 3.6 Ampere / Direct / Specified voltage AC/DC
Descrizione

RF Output 250W. Filament and Anode are Tungsten. Anode voltage 1500 - 2000. This tube was first developed in the GE Research laboratory in Schenectady New York and for a short time at a small factory set-up in Lynn Massachusetts. The original tubes were baseless but structural modifications were added, including a top cap and a three contact base. These later tubes were the Navy CG916 and Army VT10. It is mentioned on page 38 of "The Storyof Electronic Development at the General Electric Company".

 
Dimensioni
(LxAxP)
incl.pins/tip
x 356 x 127 mm / x 14.02 x 5.00 inch
Bibliografia Saga of the Vacuum Tube, Tyne   p. 143-144 and 151-152
- - Manufacturers Literature   
Tube Lore (II)


Just Qvigstad

Collezione di

 
ge_pliotron_p_e717.jpg

P_Pliotron
 

[rmxtube-en]
  

Conformità dei dati Ulteriori informazioni