8000 Model 30 late, two rheostats
Atwater Kent Mfg. Co.; Philadelphia, USA
- Produttore / Marca
- Atwater Kent Mfg. Co.; Philadelphia, USA
- Anno
- 1926
- Categoria
- Radio (o sintonizzatore del dopoguerra WW2)
- Radiomuseum.org ID
- 74614
Clicca sulla miniatura dello schema per richiederlo come documento gratuito.
- Numero di tubi
- 6
- Principio generale
- A circuiti accordati (amplif. diretta) senza reazione; 2 Stadi BF
- N. di circuiti accordati
- 3 Circuiti Mod. Amp. (AM)
- Gamme d'onda
- Solo onde medie (OM).
- Tensioni di funzionamento
- Batterie (di accumulatori e/o a secco)
- Altoparlante
- - Questo apparecchio richiede altoparlante/i esterno/i.
- Materiali
- Mobile in legno
- Radiomuseum.org
- Modello: 8000 Model 30 [late, two rheostats] - Atwater Kent Mfg. Co.;
- Forma
- Soprammobile a cassapanca o cassetta, solitamente con coperchio (NON a leggio)
- Dimensioni (LxAxP)
- 502 x 156 x 164 mm / 19.8 x 6.1 x 6.5 inch
- Annotazioni
-
Metal panel and a L-shaped chassis. Single moulded (UX) sockets for the 3 RF stages, and a moulded bakelite panel serving as the chassis for the detector and the two audio stages. This chassis panel also formed the sockets for the three (UX) tubes.
- Peso netto
- 5.6 kg / 12 lb 5.4 oz (12.335 lb)
- Fonte dei dati
- A.Atwater Kent, The Man, 2002
- Bibliografia
- Radio Manufacturers of the 1920s, Vol 1
- Letteratura / Schemi (2)
- Le Guide du Collectionneur TSF Biraud/Foster, Vol. I (page 102)
- Autore
- Modello inviato da Konrad Birkner † 12.08.2014. Utilizzare "Proponi modifica" per inviare ulteriori dati.
- Altri modelli
-
In questo link sono elencati 508 modelli, di cui 332 con immagini e 332 con schemi.
Elenco delle radio e altri apparecchi della Atwater Kent Mfg. Co.; Philadelphia, USA
Collezioni
Il modello 8000 fa parte delle collezioni dei seguenti membri.
Discussioni nel forum su questo modello: Atwater Kent Mfg. Co: 8000 Model 30
Argomenti: 1 | Articoli: 1
Receiver sensitivity is around -50 dBm over the broadcasting AM band (525 – 1500 kHz) with more than 10 dB (S+N)/N ratio. Noise level is around -65 dBm.
Compared to the Atwater Kent models 20 and 20C, with similar components, the receiver sensitivity is reduced with at least 10 dB, even if 6 tubes are used instead of 5. The problem is the alignment of the tuning circuits with a single mechanical control. In practice, for a perfect tuning, there are few % variation from a tuning circuit to another, in special in the first stage where a certain antenna tuning is preferable. However, an easier tuning is done with the model 30 than with previous tree dial models.
More details and measurements are presented in the attached pdf file.
Allegati
Serioja Tatu, 22.Dec.24