4340 Radiodyne (Metal on/off switch) (Early TA and Binding Posts)
Atwater Kent Mfg. Co.; Philadelphia, USA
- Produttore / Marca
- Atwater Kent Mfg. Co.; Philadelphia, USA
- Anno
- 1923
- Categoria
- Radio (o sintonizzatore del dopoguerra WW2)
- Radiomuseum.org ID
- 197479
- Numero di tubi
- 5
- Principio generale
- A circuiti accordati (amplif. diretta) senza reazione
- N. di circuiti accordati
- 3 Circuiti Mod. Amp. (AM)
- Gamme d'onda
- Solo onde medie (OM).
- Tensioni di funzionamento
- Batterie (di accumulatori e/o a secco)
- Altoparlante
- - Questo apparecchio richiede altoparlante/i esterno/i.
- Materiali
- Mobile in legno, valvole visibili.
- Radiomuseum.org
- Modello: 4340 Radiodyne - Atwater Kent Mfg. Co.;
- Forma
- Soprammobile con qualsiasi forma (non saputo).
- Dimensioni (LxAxP)
- 31.5 x 6 x 10 inch / 800 x 152 x 254 mm
- Annotazioni
- The first Part No. 4340 Radiodyne breadboard to come into production had an aluminum metal on/off switch and a unique TA unit. This green, 3-tube TA unit has a unique keying pattern for the tubes. Looking at the front of the TA unit, the left two of the tube key slots point to the rear of the board and the tube socket on the right the slot points to the right. Later breadboard models have one slot pointing to the left, one to the rear, and the tube socket on the right points to the right. This was done to simplify filament wiring. Finally, on very early Radiodynes, square aluminum plate switches, left over from the last run of the Models 4052 and 4066, were used instead of the familiar circular Bakelite switches. So, the Radiodyne can have either an aluminum or Bakelite switch.
- Prezzo nel primo anno
- 88.00 $
- Letteratura / Schemi (1)
- A.Atwater Kent, The Man, 2002
- Autore
- Modello inviato da Alan Larsen. Utilizzare "Proponi modifica" per inviare ulteriori dati.
- Altri modelli
-
In questo link sono elencati 508 modelli, di cui 332 con immagini e 332 con schemi.
Elenco delle radio e altri apparecchi della Atwater Kent Mfg. Co.; Philadelphia, USA