- País
- Estados Unidos
- Fabricante / Marca
- D & A Manufacturing Co.; Scottsbluff, Nebraska
- Año
- 1969
- Categoría
- Amplificador de Radiofrecuencia
- Radiomuseum.org ID
- 365228
Courtesy of Keith Wright.
Courtesy of Keith Wright.
Courtesy of Keith Wright.
Courtesy of Keith Wright.
Courtesy of Keith Wright.
Courtesy of Keith Wright.
Courtesy of Keith Wright.
- Numero de valvulas
- 3
- Gama de ondas
- Onda Corta solamente
- Tensión de funcionamiento
- Red: Corriente alterna (CA, Inglés = AC) / 117 Volt
- Altavoz
- - - No hay salida de sonido.
- Material
- Metálico
- de Radiomuseum.org
- Modelo: Hawk - D & A Manufacturing Co.;
- Forma
- Sobremesa de cualquier forma, detalles no conocidos.
- Ancho, altura, profundidad
- 7 x 5 x 6 inch / 178 x 127 x 152 mm
- Anotaciones
-
Hawk 25W RF linear amplifier.
There were at least three versions of this model, all versions are included on this model page. Note that all models have a variable TUNING (or TUNE) capacitor; the two later versions have an added BAND switch.
Model Band Switch (Meters) Frequency (MHz) Hawk (early) none 20-35 Hawk (mid) 10*, 15, 20, 40 7.5-30 Hawk (late) 10, 15, 20, 40 7.5-30 * The 10M Band setting on the middle version is assumed since the only photo found indicates a 4-position switch with band decals "40", "20", and "15" intact but the switch is pointing to where the "10" decal should be.
- Peso neto
- 6 lb (6 lb 0 oz) / 2.724 kg
- Precio durante el primer año
- 59.95 USD
- Documentación / Esquemas (1)
- -- Original prospect or advert (Popular Electronics, Sept. 1969, page 119.)
- Autor
- Modelo creado por Jerry Elarton. Ver en "Modificar Ficha" los participantes posteriores.
- Otros modelos
-
Donde encontrará 5 modelos, 3 con imágenes y 0 con esquemas.
Ir al listado general de D & A Manufacturing Co.; Scottsbluff, Nebraska