3 Band Dynamic Range Expander 3BX
dbx Inc.; Waltham (MA)
- País
- Estados Unidos
- Fabricante / Marca
- dbx Inc.; Waltham (MA)
- Año
- 1977 ?
- Categoría
- Amplificador de audio o mezclador
- Radiomuseum.org ID
- 187560
Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.
- Numero de transistores
- Hay semiconductores.
- Semiconductores
- Principio principal
- Amplificador de Audio
- Gama de ondas
- - no hay
- Tensión de funcionamiento
- Red: Corriente alterna (CA, Inglés = AC) / 220 Volt
- Altavoz
- - Este modelo usa amplificador externo de B.F.
- Material
- Metálico
- de Radiomuseum.org
- Modelo: 3 Band Dynamic Range Expander 3BX - dbx Inc.; Waltham MA
- Forma
- Sobremesa de cualquier forma, detalles no conocidos.
- Ancho, altura, profundidad
- 450 x 95 x 255 mm / 17.7 x 3.7 x 10 inch
- Anotaciones
-
Tape noise reduction system continuously ajustable from 1x to 1,5x. S/N 110dB; Z-in: 50K; V-in:300mV; Z-out: 0,1K; Freq-range: 20-20000Hz.
This apparatus must be inserted between the amplifier and the recorder. Works with any recorder because the compression is linear in contrast to Dolby-NR or Dolby-B where the reproduction level must match the recording level.
No DBX disc capability.
Splits the audio band in 3 bands which are treated apart.Exspansion: 1:1.5 maximum each band
Dynamic Range: 110dB (peak signal to weighted background noise ratio)
Transition Level range (treshold): 30mV to 3V (mid-band)
Attack and Release Rates (response time): Programe dependant, optimized for each frequency band
Frequency Response: +-0.5dB, 20hz to 20kHz at an expansion ratio 1.0:1
Harmonic Distortion: 0.1% 20Hz to 20kHz at any exspansion settings
Intermodulation Distortion: less than or equal to 0.5% per SMPTE method
Input noise: 90dB below 1 Volt "A" weighted
Input impedance: 50kOhms
Output impedance: The 3BX is designed to feed tape recorder inputs of 5kOhms or greater
Maximum output level: 7 Volts RMS at 1kHz into 5kOhms load
Power requirements: 117V AC, 50 or 60Hz, 30Watts Maximum, EU models wired for 220V and 240V
- Peso neto
- 3.9 kg / 8 lb 9.4 oz (8.59 lb)
- Precio durante el primer año
- 42,500.00 Bfr
- Procedencia de los datos
- -- Original prospect or advert
- Autor
- Modelo creado por Dirk Bladt. Ver en "Modificar Ficha" los participantes posteriores.
- Otros modelos
-
Donde encontrará 26 modelos, 25 con imágenes y 4 con esquemas.
Ir al listado general de dbx Inc.; Waltham (MA)
Colecciones
El modelo 3 Band Dynamic Range Expander es parte de las colecciones de los siguientes miembros.