radiomuseum.org

Barney Oliver Amplifier

Barney Oliver Amplifier ; Hewlett-Packard, HP; (ID = 1918348) Ampl/Mixer
 
Barney Oliver Amplifier ; Hewlett-Packard, HP; (ID = 1918350) Ampl/Mixer
 
Barney Oliver Amplifier ; Hewlett-Packard, HP; (ID = 1919144) Ampl/Mixer
 
Barney Oliver Amplifier ; Hewlett-Packard, HP; (ID = 1919145) Ampl/Mixer
 
Barney Oliver Amplifier ; Hewlett-Packard, HP; (ID = 1919146) Ampl/Mixer
 
Barney Oliver Amplifier ; Hewlett-Packard, HP; (ID = 1926522) Ampl/Mixer
 
Barney Oliver Amplifier ; Hewlett-Packard, HP; (ID = 1926523) Ampl/Mixer
 
Barney Oliver Amplifier ; Hewlett-Packard, HP; (ID = 1926524) Ampl/Mixer
 
Barney Oliver Amplifier ; Hewlett-Packard, HP; (ID = 1936287) Ampl/Mixer
 
Barney Oliver Amplifier ; Hewlett-Packard, HP; (ID = 1936288) Ampl/Mixer
Barney Oliver Amplifier ; Hewlett-Packard, HP; (ID = 1917006) Ampl/Mixer
Utilice la barra deslizante rojo por más.
Barney Oliver Amplifier ; Hewlett-Packard, HP; (ID = 1917006) Ampl/Mixer
Hewlett-Packard, HP;: Barney Oliver Amplifier [Ampl/Mixer] ID = 1917006 1217x475
Seleccione una imagen o esquema para mostrar las miniaturas de la derecha y haga clic para descargar.
For model Barney Oliver Amplifier, Hewlett-Packard, (HP); Palo Alto, CA:
Picture supplied by Dr. Nico Ras (South Africa), amplifier in original state with original knobs and HP logo.
 
País:  Estados Unidos
Fabricante / Marca:  Hewlett-Packard, (HP); Palo Alto, CA
Año: 1972 Categoría: Amplificador de audio o mezclador
Semiconductores (sólo se cuentan los transistores) Hay semiconductores. 2N2405 2N3904 2N3906 2N4036 2N4044 2N5401 2N5551 MJ802 MJ4502
Principio principal Amplificador de Audio; Hi-Fi-High End products
Gama de ondas - no hay
Especialidades Hi-Fi equipment
Tensión de funcionamiento Red: Corriente alterna (CA, Inglés = AC) / 115/230 Volt
Altavoz - Este modelo usa altavoz exterior (1 o más).
Potencia de salida 160 W (320 W max.)
de Radiomuseum.org Modelo: Barney Oliver Amplifier - Hewlett-Packard, HP; Palo Alto
Material Metálico
Forma Unidad para estanteria.
Ancho, altura, profundidad 425 x 127 x 278 mm / 16.7 x 5 x 10.9 inch
Anotaciones

Integrated stereo amplifier.

Very rare item (only 500 were made, for HP employees, their relatives and friends).

Output 2 x 80W continuous in 8 or 16 Ohms (4 Ohms not recommended).

Inputs for Tuner, Tape, Aux 1, Aux 2 and Phono (optimized for Shure V15 II).

Sensitivity phono: < 5 mV, signal-to-noise ratio 84 dB (referred to 1 V output).

Sensitivity other inputs: < 1 V at 100 k.

Signal-to-noise ratio of power amplifier 100 dB (compared to max output).

THD < 0.01% from 2 mW output to max. power at all frequencies.

Volume control with dual precision attenuator, 60 dB range, 2 dB steps. Eliminates need for separate balance control.

Tone controls (treble, bass, range +6 to -6 dB)

Stereo/stereo reverse/mono L/mono R, dual mono operation also possible (separate use of each channel)

Noise filter: corner frequency 5 or 8 or 20 or 100 kHz, 18 dB/octave, with 30 dB notch at 10 kHz in the 5 and 8 kHz positions

NB Barney (Dr. Bernard M) Oliver was HP's vice president for research and development, and the designer of this amplifier. This explains the model name. He is also the author of an article entitled "Distortion in Complementary-Pair Class-B Amplifiers" which appeared in Hewlett Packard Journal, February 1971, Volume 22, Number 6, Pages 1-6.

Peso neto 20 lb (20 lb 0 oz) / 9.080 kg
Precio durante el primer año 325.00 US$
Mencionado en - - Manufacturers Literature (Hewlett Packard Barney Oliver Amplifier Memo)
Documentación / Esquemas (1) -- Original-techn. papers. (Hewlett Packard Barney Oliver Amplifier Manual)

Modelo creado por Aren van Waarde. Ver en "Modificar Ficha" los participantes posteriores.



Ir al listado general de Hewlett-Packard, (HP); Palo Alto, CA
Donde encontrará 356 modelos, 322 con imágenes y 123 con esquemas.



  
rmXorg