Stereo Amplifier SA-510

Pioneer Corporation; Tokyo

  • Año
  • 1980/1981
  • Categoría
  • Amplificador de audio o mezclador
  • Radiomuseum.org ID
  • 193620

 Especificaciones técnicas

  • Numero de transistores
  • 26
  • Semiconductores
  • Principio principal
  • Amplificador de Audio
  • Gama de ondas
  • - no hay
  • Especialidades
  • Hi-Fi equipment
  • Tensión de funcionamiento
  • Red: Corriente alterna (CA, Inglés = AC) / 110; 120; 220; 240 Volt
  • Altavoz
  • - Este modelo usa altavoz exterior (1 o más).
  • Potencia de salida
  • 60 W (undistorted)
  • Material
  • Metálico
  • de Radiomuseum.org
  • Modelo: Stereo Amplifier SA-510 - Pioneer Corporation; Tokyo
  • Forma
  • Unidad para estanteria.
  • Ancho, altura, profundidad
  • 420 x 94 x 347 mm / 16.5 x 3.7 x 13.7 inch
  • Anotaciones
  • A hi-fi stereo integrated amplifier housed in a metal case with continuous power output of 30 watts per channel into 8 ohms. With fluorescent power meter, rotary controls for Volume, Balance, Bass and Treble, rotary Function selector (Tuner, Phono, Tape1, Aux), switches for Tape2, Loudness and Subsonic filter, rotary switch for Loudspeakers (Off, A, B) and a jack for headphones. On the rear panel, RCA phono sockets for input Phono, Tuner and Aux, for input/output Tape1 and Tape2, terminals for 2 pairs of loudspeakers  (A, B) and 3 AC outlets (except YP), 2 switched and 1 unswitched.

    Specification  
    Amplifier Section  
    Continuous Power Output 30 watts per channel into 8Ω
    from 20Hz to 20,000Hz
    with no more than 0.03% THD
    Total Harmonic Distortion
     (20Hz-20,000Hz, 8Ω, from AUX)
     15 watts per channel power output 
    No more than 0.02%
    Intermodulation Distortion
     continuous rated power output
     15 watts per channel power output
    No more than 0.03%
    No more than 0.02%
    Damping Factor (20Hz-20,000Hz, 8Ω) 40
    Input (Sensitivity/Impedance)  
     PHONO
     TUNER
     AUX
     TAPE PLAY 1, 2
    2.5mV/50kΩ
    150mV/50kΩ
    150mV/50kΩ
    150mV/50kΩ
    Output (Level)  
     TAPE REC 1, 2
     Speaker
    150mV
    A, B, OFF
    Frequency Response  
     PHONO (RIAA Equalization)
     TUNER, AUX, TAPE PLAY 1, 2
    20Hz to 20,000Hz ±0.3dB
    10Hz to 60,000Hz ±3dB
    Subsonic Filter 15Hz (-6dB/Oct)
    Hum and Noise
     (IHF, short-circuited, A network)
     
     PHONO
     TUNER, AUX, TAPE PLAY 1, 2
    82dB
    100dB
    Hum and Noise
    (DIN, continuous Power/50mW)
     
     PHONO
     TUNER, AUX, TAPE PLAY 1, 2
    68dB/58dB
    85dB/60dB

    Versions/Power requirements

    KU   USA 120V AC 60Hz
    S     General export 110V, 120V, 220V and 240V AC 50/60Hz (with voltage selector)
    S/G US Military 110V, 120V, 220V and 240V AC 50/60Hz (with voltage selector)
    HE  Europe 220V AC 50/60Hz
    HB  UK 240V AC 50/60Hz
    YP  Australia  240V AC 50/60Hz

    Power consumption: 220 watts (HE, HB, YP),  85 watts (S/G, S), 80 watts (KU)

  • Peso neto
  • 6 kg / 13 lb 3.5 oz (13.216 lb)
  • Mencionado en
  • Discoteca HiFi, Anno XXI, n. 208-209, Agosto-Settembre 1980, Italy
  • Documentación / Esquemas (1)
  • - - Manufacturers Literature (1980/81 Pioneer Hi-Fi Stereo catalogue)
  • Documentación / Esquemas (2)
  • - - Manufacturers Literature (Operating Instructions Pioneer SA-510)
  • Documentación / Esquemas (3)
  • - - Manufacturers Literature (Service manual Pioneer SA-510 dated Apr 1980)
  • Autor
  • Modelo creado por Alessandro De Poi. Ver en "Modificar Ficha" los participantes posteriores.

 Colecciones | Museos | Literatura

Colecciones

El modelo Stereo Amplifier es parte de las colecciones de los siguientes miembros.

 Forum