Folkemottager Nett2

Folkemottager ; Radionette; Oslo (ID = 1314154) Radio Folkemottager ; Radionette; Oslo (ID = 1314158) Radio
Folkemottager ; Radionette; Oslo (ID = 1314159) Radio Folkemottager ; Radionette; Oslo (ID = 1314160) Radio
Folkemottager ; Radionette; Oslo (ID = 1314161) Radio Folkemottager ; Radionette; Oslo (ID = 1314162) Radio
Altre immagini: scorri con la barra rossa.
Folkemottager ; Radionette; Oslo (ID = 1314154) Radio
Radionette; Oslo: Folkemottager [Radio] ID = 1314154 900x573
Seleziona le anteprime di foto e schemi a destra per ingrandirle, e clicca qui sopra per il download.
For model Folkemottager Nett2, Radionette; Oslo
Paese:  Norvegia
Produttore / Marca:  Radionette; Oslo
Anno: 1937 ?? Categoria: Radio (o sintonizzatore del dopoguerra WW2)
Valvole 3: E446 E453_6pin 506
Principio generale A circuiti accordati (TRF o amplif. diretta in generale); 1 Stadi BF
N. di circuiti accordati 1 Circuiti Mod. Amp. (AM)
Gamme d'onda Onde medie (OM) e onde lunghe (OL).
Tensioni di funzionamento Alimentazione a corrente alternata (CA) / 230 Volt
Altoparlante AP elettrodinamico (bobina mobile e bobina di eccitazione/di campo) / Ø 16 cm = 6.3 inch
Potenza d'uscita Modello: Folkemottager [Nett2] - Radionette; Oslo
Materiali Mobile in legno
Forma Soprammobile con qualsiasi forma (non saputo).
Dimensioni (LxAxP) 430 x 250 x 205 mm / 16.9 x 9.8 x 8.1 inch
Peso netto 7.5 kg / 16 lb 8.3 oz (16.52 lb)

Modello inviato da Wolfgang Möller. Utilizzare "Proponi modifica" per inviare ulteriori dati.

Elenco delle radio e altri apparecchi della Radionette; Oslo
In questo link sono elencati 134 modelli, di cui 124 con immagini e 45 con schemi.


Discussioni nel forum su questo modello
Radionette; Oslo: Folkemottager
Argomenti: 1 | Articoli: 5
Visite: 1007     Risposte: 4
radionette: incoherent socket on Folkemottager Nett2
Pierre De Man

I just got a Folkemottager Nett2 with no tube. The output pentode is supposed to be E453-6 pin, but the corresponding socket (in the middle) looks like a P8A-8pin.

I wish to know what tube could have been used in this radio.  The cabling uses 7 of the 8 contacts of the sockets.  

Any hints would be welcome.


Jacob Roschy

Hello Pierre,

there is no direct successor of the E453. As 7 contacts are wired, it's most likely the very common AL4 was used as substitute.
Note the grid bias voltages of E453 and AL4 are very different, so a bias re-matching might be necessary.

Best Regards, Jacob 

Pierre De Man

Hello Jacob,

thank you for this information, it seems indeed a serious candidate. 

I think this socket swap has been made by the previous owner. It is fixed by means of screws (not rivets). Some capacitors seems also more recent than others. The bias could have been adapted.

Anyway I will have to draw the schematic to compare with the regular schematic and possibly confirm AL4. 




Pierre De Man

After checking the wiring of my radio, the cathode resistor of the output pentode is around 110 ohm which seems consistent with what is adviced for the AL4 (E453 would need 500 ohms). Jacob, I think you were right.



Jacob Roschy

Hello Pierre,

the choice of P8-base substitute types for the E453 is rather small, only the types AL1, AL2, AL3 and AL4 are more or less qualified.

7 wired contacts fits only to AL3 and AL4, whereby the AL3 was only short-lived and is almost identical to the AL4.

The AL2 has a top grid cap, hence without control grid at the socket, the AL1 is directly heated, hence without cathode connection on the socket.

Regards, Jacob


Radionette; Oslo: Folkemottager
Fine delle discussioni nel forum su questo modello