Variable Persistence Storage Oscilloscope 7613

Tektronix; Portland, OR

  • Jahr
  • 1973
  • Kategorie
  • Service- oder Labor-Ausrüstung
  • Radiomuseum.org ID
  • 225491

 Technische Daten

  • Hauptprinzip
  • kein Zusatz
  • Wellenbereiche
  • - ohne
  • Betriebsart / Volt
  • Wechselstromspeisung / 100; 110; 120; 200; 220; 240 Volt
  • Lautsprecher
  • - - Kein Ausgang für Schallwiedergabe.
  • Material
  • Metallausführung
  • von Radiomuseum.org
  • Modell: Variable Persistence Storage Oscilloscope 7613 - Tektronix; Portland, OR
  • Form
  • Tischmodell, Zusatz nicht bekannt - allgemein.
  • Abmessungen (BHT)
  • 8.7 x 11.4 x 24 inch / 221 x 290 x 610 mm
  • Bemerkung
  • The 7613 Storage Oscilloscope offers Variable Persistence operation with a stored writing speed of 5 div/µs or conventional (nonstorage) operation. Stored traces can be viewed up to 60 minutes on a display area of 8 x 10 div (0.9 cm/div). The 7613 CRT is extremely burn resistant and doesn't require any special operating precautions.

    VERTICAL
    Channels: Two left-hand plug-in compartments; compatible with all 7000-Series plug-ins. Bandwidth determined by mainframe and plug-in unit
    Chopped Mode: Repetition rate is approximately 1 MHz.
    Delay Line: Permits viewing leading edge of displayed waveform.

    HORIZONTAL
    Channels: One right-hand plug-in compartment; compatible with all 7000-Series plug-ins.
    Fastest Calibrated Sweep Rate: 5 ns/div with the 7B53A or 7B53AN.
    X-Y Mode: The phase shift between vertical and horizontal channels is 2° from DC to 35 kHz.
    Bandwidth: DC to at least 2 MHz


    Variable Persistence Storage CRT: Internal 8 x 10 div (0.9 cm/div) graticule with variable illumination.

    Option 6, Special Internal Graticule (Spectrum Analyzer): Internal 8 x 10 div (0.9 cm/div) with variable illumination including LIN, LOG and FREQUENCY markings.

    Accelerating Potential: 8.5 kV. Phosphor: P31.

    Non-Store Mode: For displaying waveforms in the conventional (non-storage) mode.

    Store Mode: For displaying waveforms utilizing the variable persistence storage feature.

    Stored Writing Speed: Greater than 5 div/µs.

    Storage View Time: may be increased by selecting SAVE and adjusting for reduced viewing brightness with SAVE TIME control.

    Erase Time: 0.5 s or less.

    Persistence: Continuously variable, persistence may be turned off when not needed.

    External 2-Axis Input: 2V P-P for full intensity range from DC to 2 MHz, intensity range diminishes to 20% of full range at 10 MHz. A positive signal blanks the trace. Maximum Input voltage is 10V (DC + Peak AC) and P-P AC.

    Auto-Focus: Reduces the need for additional manual focusing with changes in intensity after focus control has been initially set.
    Beam Finder: Limits display within Graticule area.
     

  • Nettogewicht
  • 30 lb 0 oz (30 lb) / 13.620 kg
  • Originalpreis
  • 2,500.00 USD
  • Autor
  • Modellseite von Pius Steiner angelegt. Siehe bei "Änderungsvorschlag" für weitere Mitarbeit.

 Sammlungen | Museen | Literatur

Sammlungen

Das Modell Variable Persistence Storage Oscilloscope befindet sich in den Sammlungen folgender Mitglieder.

 Forum