H664 Ch= 6H02
Zenith Radio Corp.; Chicago, IL
- Pays
- Etats-Unis
- Fabricant / Marque
- Zenith Radio Corp.; Chicago, IL
- Année
- 1951 ?
- Catégorie
- Radio - ou tuner d'après la guerre 1939-45
- Radiomuseum.org ID
- 68220
-
- alternative name: Chicago Radio Lab
Cliquez sur la vignette du schéma pour le demander en tant que document gratuit.
- No. de tubes
- 6
- Principe général
- Super hétérodyne (en général); FI/IF 455 kHz; 2 Etage(s) BF
- Circuits accordés
- 6 Circuits MA (AM)
- Gammes d'ondes
- PO uniquement
- Particularités
- Tourne disque / changeur (châssis)
- Tension / type courant
- Alimentation Courant Alternatif (CA) / 60 Hz, 117V = 110 -120 Volt
- Haut-parleur
- HP dynamique à aimant permanent + bobine mobile / Ø 7.5 inch = 19.1 cm
- Matière
- Boitier en bois
- De Radiomuseum.org
- Modèle: H664 Ch= 6H02 - Zenith Radio Corp.; Chicago,
- Forme
- Modèle de table générique
- Remarques
-
Zenith model H664 is an AC operated combination phono-radio, superheterodyne receiver with loop antenna.
- Source extérieure
- Ernst Erb
- Source du schéma
- Rider's Perpetual, Volume 22, covering 1951
- Littérature
- Collector's Guide to Antique Radios 4. Edition
- Schémathèque (1)
- Beitman Radio Diagrams, Vol. 11, 1951
- Schémathèque (2)
- Photofact Folder, Howard W. SAMS (Set 149, folder 15, dated 11-51)
- D'autres Modèles
-
Vous pourrez trouver sous ce lien 4517 modèles d'appareils, 4109 avec des images et 3652 avec des schémas.
Tous les appareils de Zenith Radio Corp.; Chicago, IL
Collections
Le modèle H664 fait partie des collections des membres suivants.
Contributions du forum pour ce modèle: Zenith Radio Corp.;: H664 Ch= 6H02
Discussions: 2 | Publications: 6
I'm working on a restoration of a Zenith tabletop radio/turntable that I bought at the closing of an electronics store. After doing a recap of the most obvious capacitors, I tested the voltages of the tubes according to the scematics and all of the voltages came in almost right on with two exceptions:
1. 6AQ6 - Pin 7 should be 48V and it came in at 30V. I bought a new tube and the voltage measured 37V, an improvement, but clearly something still wrong.
2. I was not able to get any reading out of the Phono Pre-Amp (12J5) even after buying a replacement bulb. Of course, I have the radio part of the device out of the shell and the turntable is not connected so that may have something to do with this. Right or wrong?
3. I am unable to get a signal on the radio, just some static and a few spots where it perks up, but no meaningful sound. I don't think that there's an antenna connected so would that be the reason for this or is there a problem elsewhere?
I'm looking for any direction to help with these items.
thanks you in advance!
craig.
Craig Vodnik, 06.Jan.13
Does anyone know the specifications (or can read the schematics) for the dial bulb of this model? I have the burned out one on hand, but it has no specs written on it and the parts list in the schematics only calls it PL-1. It's a bayonet style.
Thanks!
craig.
Craig Vodnik, 31.Dec.12