radiomuseum.org
Please click your language flag. Bitte Sprachflagge klicken.

455A

Information - Help 
ID = 78062
       
 
   
Tube type:  Vacuum Pentode   Audio Frequency 
  Ca. 1925 up to 1945 extraordinarily rare. Production was less than 100 items. ****
Identical to 455A
Predecessor Tubes 175HQ  

Was used by Telephony
Filament Indirect / Specified current DC = (Series working)
Description

After the experience gained on the 175HQ high-rel pentode, over than 80 million-hours of reliable operation already totalized, Bell Telephone started designing the 455A for the new transoceanic multi-channel SD system. The system requirements appeared definitely impossible to approach: 20 years of uninterrupted service were espected. The system had to transmit 128 audio channels, 3 KHz bandwidth, in each direction over a single coaxial cable. The distance, over than 3500 miles, required the use of 183 signal repeaters, one every 20 miles, each repeater containing six high-gm tubes: a total of 1098 tubes. For tube failures not minimized by redundancies a mean time between failures of 26,100 years was required. Duplicating amplifiers in each repeater cell and neglecting parametric variations through the system life, the estimated m.t.b.f. for this tube dropped to a mere 885 years!

Production of the tubes at the Allentown Works of Western Electric went on for about four years. In the production for most operation each operator carried out six tubes at a time, updating the related tracking record. The design philosophy, as well as the production approach were derived from those applied for the 175HQ with even more selective control steps. Every tube and every element inside, cathode, grids and anode, were identified by serial numbers and complete traceability was kept of each significative operation and of every lot of material batches and of group of parts. Even absolute cleaning from oxides, grease and any contaminant agent, as well as storage in clean containers for a limited time were mandatory through the some 350 operations of the manufacturing process. Ten inspections, six of which for searching unwanted particles, were performed through the manufacture of each tube.

Each tube was aged for 5000 hours and tested six times through the aging. Individual electrical characteristics and relevant parameters were recorded. The full story of each tube and every deviation were carefully evauated by a selection committee. Tubes were finally selected in groups of six, A to F, as kit for each repeater. Selection was made evaluating the total heater voltage drop, the transconductance and even the noise, the ones with lower noise being assigned to input stages.

The full article from the BST Journal, July 1964 describing this outstanding tube can be downloaded ath the link below (About 14 M)

ase-museoedelpro.org/Museo_Edelpro/Catalogo/tubes/records_nw/455A/bstj43-4-1311.pdf

The description of the line amplifiers of the SD system is given in the BSTJ below:

ase-museoedelpro.org/Museo_Edelpro/Catalogo/tubes/records_nw/455A/bstj43-4-1243.pdf

 
Information source - - Manufacturers Literature   

Collection of

 
455a_07.jpg

455A
 

You reach this tube or valve page from a search after clicking the "tubes" tab or by clicking a tube on a radio model page. You will find thousands of tubes or valves with interesting links. You even can look up radio models with a certain tube line up. [rmxtube-en]
  

Data Compliance More Information