radiomuseum.org

Expanse-B

Informazioni - Aiuto 
ID = 30794
       
Stato:
Australia
Produttore: Amalgamated Wireless (Australasia) Ltd. (AWA); Sydney
Progettista: Amalgamated Wireless (Australasia) Ltd. (AWA); Sydney 
Tipo:  Triodo a gas   Detector 
Identico a Expanse-B
Prime serie 1920 Saga of the Vacuum Tube, Tyne page 273
Fine produzione 1923
Sostituisce i modelli Expanse  

Zoccolo Wires
Utilizzata per Radio/TV-reception etc.
Filamento Vf 5 Volt / Direct / Battery =
Descrizione

Made by AWA Ltd.(Amalgamated Wireless Australasia Limited, 97 Clarence Street, Sydney), this soft tube had no contacting socket but wire leads. It used double filament. Production continued from 1920 to about the end of 1923. Early versions of the valve had ebonite caps 15 mm diameter. Later valves had bakelite caps with a diameter if 13 mm. It is not known when this change took place. Each valve had a serial number stamped on the anode and the highest serial number found so far is just over 10000. There is no information available to show exactly how many were made. Tube boxes located show that the tubes were packed in "raw" wool.

 
Dimensioni
(LxAxP)
incl.pins/tip
x 90 x 25 mm / x 3.54 x 0.98 inch
Peso 25 g / 0.88 oz
Quotazioni 2 Quotazioni (visibili solo per gli associati)
Bibliografia Saga of the Vacuum Tube, Tyne   Pages 273-275 and 467
70 Years of Radiotubes and V.   Page 187

tf2~~1.png Expanse-B: Fin Stewart
Fin Stewart

aus_awa_expanse_b_notes.png
Expanse-B: Manufacturers info
Gary Cowans

Utilizzo nei modelli 1= 1920?

Numero totale di modelli di Radiomuseum.org che utilizzano questa valvola:1

Collezione di

 
expanse_b.jpg

Segue ...
 

[rmxtube-en]
  

Conformità dei dati Ulteriori informazioni