• Jahr
  • 1925 ?
  • Kategorie
  • Bausatz, Baukasten oder Bauanleitung (Kit)
  • Radiomuseum.org ID
  • 336932

Klicken Sie auf den Schaltplanausschnitt, um diesen kostenlos als Dokument anzufordern.

 Technische Daten

  • Anzahl Röhren
  • 4
  • Hauptprinzip
  • Spezialschaltung (siehe Bemerkungen); 3 NF-Stufe(n); Reflex
  • Wellenbereiche
  • Mittelwelle, keine anderen.
  • Betriebsart / Volt
  • Akku und/oder Batterie / 90; 6; 4.5 Volt
  • Lautsprecher
  • - Dieses Modell benötigt externe(n) Lautsprecher.
  • Material
  • Gerät mit Holzgehäuse
  • von Radiomuseum.org
  • Modell: Acmeflex Model A - Acme Apparatus Co.; Cambridge
  • Form
  • Tischgerät, Truhenform, meist mit Deckel (NICHT Schrägpult).
  • Bemerkung
  • Radio is unique because of its reflex design, single tuned stage, and panel-mounted crystal detector. The radio must be connected to a loop antenna to complete the tuned circuit. Selectivity is poor, but would have been adequate in 1925. If a tuned loop is used, the radio can be tuned across most of the AM band with much better selectivity.  Rheostat controls filaments of all 4 tubes.  Potentiometer controls bias on first tube grid.  Acme put the rheostat and pot in a concentric arrangement.  The crystal detector has a coarse adjustment and a small vernier to help move the internal cat whisker.  This detector works very well and once set it requires very little attention. It was in a cheaply made pine box with a plain bakelite front panel.  It was intended to be low cost compared to other radios at that time, but still provides adequate sensitivity and enough power to clearly drive a horn or loudspeaker of that time.

    Everything in the Kit except tubes, batteries and speaker.

  • Literatur/Schema (1)
  • -- Schematic
  • Autor
  • Modellseite von Tim McVey angelegt. Siehe bei "Änderungsvorschlag" für weitere Mitarbeit.

 Sammlungen | Museen | Literatur

Sammlungen

Das Modell Acmeflex befindet sich in den Sammlungen folgender Mitglieder.

 Forum