- País
- Australia
- Fabricante / Marca
- Airzone (1931) Ltd.; Sydney
- Año
- 1959
- Categoría
- Televisión (TV) o monitor
- Radiomuseum.org ID
- 296140
- Numero de valvulas
- 17
- Válvulas
- 6BQ7A 6CQ8 6CB6 6U8 6CB6 12BY7 6AU6 6AL5 6BV7 6SN7GTA 6AQ5 6SN7GTA 6DQ6A 6AX4GT 1B3GT 5AS4 21CBP4A
- Numero de transistores
- Semiconductores
- GEX34
- Principio principal
- Superheterodino con paso previo de RF; ZF/IF 36000/30500 kHz; 1 Etapas de AF
- Gama de ondas
- VHF/UHF (see notes for details)
- Tensión de funcionamiento
- Red: Corriente alterna (CA, Inglés = AC) / 200; 230; 240 Volt
- Altavoz
- Altavoz dinámico (de imán permanente) / Ø 5 inch = 12.7 cm
- Potencia de salida
- 3 W (undistorted)
- Material
- Madera
- de Radiomuseum.org
- Modelo: A216 - Airzone 1931 Ltd.; Sydney
- Forma
- Sobremesa de cualquier forma, detalles no conocidos.
- Ancho, altura, profundidad
- 24 x 24 x 22 inch / 610 x 610 x 559 mm
- Anotaciones
-
21 inch B&W television receiver tunes the ten then standard Australian VHF channels.
Rebadged version of AWA Model 225.Cabinet finishes available in Walnut, Maple & Mahogany.
See also Westinghouse model W216.
- Precio durante el primer año
- 173.25 AUS £
- Documentación / Esquemas (1)
- J.R. Publications Television Service Handbook (L.J. Series Vol. 1, 1962 & 1967, Page A85.)
- Autor
- Modelo creado por Martin Kent. Ver en "Modificar Ficha" los participantes posteriores.
- Otros modelos
-
Donde encontrará 283 modelos, 133 con imágenes y 154 con esquemas.
Ir al listado general de Airzone (1931) Ltd.; Sydney
Contribuciones en el Foro acerca de este modelo: Airzone 1931 Ltd.;: A216
Hilos: 1 | Mensajes: 5
I have an Airzone TV that the circuit matches perfectly with the AWA 225. This model, the Airzone A216T is claimed to be a rebadge of the AWA 225 but has a different valve line-up and two more diodes on the model page here.
I also see no other Airzone TV model listed with a valve and semiconductor line-up that matches the AWA 225 and match the Airzone badged TV in my possession.
Either the A216 is NOT a rebadge of the AWA 225 or the valve and semiconductor listing for this model is incorrect. I have not found any other AWA model that matches this valve and semiconductor line-up.
Perhaps the model page creator or another contributor could check the source of information for these rebadged AWA models and clear up this inconsistency.
John Pratt, 22.Dec.23