- Land
- USA
- Hersteller / Marke
- DuMont Labs, Allen B., Inc.
- Jahr
- 1956
- Kategorie
- Rundfunkempfänger (Radio - oder Tuner nach WW2)
- Radiomuseum.org ID
- 82578
-
- anderer Name: Dumont Television & Radio
Klicken Sie auf den Schaltplanausschnitt, um diesen kostenlos als Dokument anzufordern.
- Anzahl Röhren
- 5
- Hauptprinzip
- Superhet allgemein; ZF/IF 455 kHz; 2 NF-Stufe(n)
- Anzahl Kreise
- 6 Kreis(e) AM
- Wellenbereiche
- Mittelwelle, keine anderen.
- Betriebsart / Volt
- Wechselstromspeisung / 110 - 120 Volt
- Lautsprecher
- Dynamischer LS, keine Erregerspule (permanentdynamisch) / Ø 4 inch = 10.2 cm
- Material
- Plastikgehäuse (nicht Bakelit), Thermoplast
- von Radiomuseum.org
- Modell: 1120 - DuMont Labs, Allen B., Inc.
- Form
- Tischgerät ohne Drucktasten, bis 35 cm Breite (Kleingerät, meist dekorativ. Nur für Netzbetrieb, doch Transportgriff möglich).
- Bemerkung
- The Dumont Model 1120 is an AC Operated 5 Tube AM Receiver.
- Schaltungsnachweis
- Beitman Radio Diagrams Vol. 17, 1957
- Literatur/Schema (1)
- Photofact Folder, Howard W. SAMS (Date 4-57, Set 354, Folder 4)
- Autor
- Modellseite von Egon Penker angelegt. Siehe bei "Änderungsvorschlag" für weitere Mitarbeit.
- Weitere Modelle
-
Hier finden Sie 299 Modelle, davon 157 mit Bildern und 241 mit Schaltbildern.
Alle gelisteten Radios usw. von DuMont Labs, Allen B., Inc.
Forumsbeiträge zum Modell: DuMont Labs, Allen B: 1120
Threads: 2 | Posts: 6
I'm preparing to restore the circuit of a Dumont 1120. I noticed that the measured resistances for couplet were far off. The 470K resistor between pin 5 and pin7 measured 1.8M ohms. The other 470K resistor between pin 6 and pin 4 measured 5.5M ohms. And the 10Meg resistor between Pin 1 and Pin4 measured 16.5M ohms.
Is it common for these to fail? I just had to rebuild one on a Sylvania R518 couplet.
Schematic included by DR
Anlagen
- Couplet (49 KB)
Jay Graven, 01.Oct.21
Restoring a Dumont 1120 clock radio. Unfortunately all four screw posts have broken away from the cabinet. I still have the broken posts attached to the screws. Anyone know a good way to reglue the broken posts back to the cabinet? Will JB Weld work??
Jay Graven, 27.Sep.21