• Año
  • 1956
  • Categoría
  • Radio - o Sintonizador pasado WW2
  • Radiomuseum.org ID
  • 82578
    • alternative name: Dumont Television & Radio

Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.

 Especificaciones técnicas

  • Numero de valvulas
  • 5
  • Principio principal
  • Superheterodino en general; ZF/IF 455 kHz; 2 Etapas de AF
  • Número de circuitos sintonía
  • 6 Circuíto(s) AM
  • Gama de ondas
  • OM (onda media) solamente
  • Tensión de funcionamiento
  • Red: Corriente alterna (CA, Inglés = AC) / 110 - 120 Volt
  • Altavoz
  • Altavoz dinámico (de imán permanente) / Ø 4 inch = 10.2 cm
  • Material
  • Plástico moderno (Nunca bakelita o catalina)
  • de Radiomuseum.org
  • Modelo: 1120 - DuMont Labs, Allen B., Inc.
  • Forma
  • Sobremesa de tamaño mediano sin botonera <= 35 cm. (Incluso portables pero sólo con alimantación por red).
  • Anotaciones
  • The Dumont Model 1120 is an AC Operated 5 Tube AM Receiver.
  • Referencia esquema
  • Beitman Radio Diagrams Vol. 17, 1957
  • Autor
  • Modelo creado por Egon Penker. Ver en "Modificar Ficha" los participantes posteriores.

 Colecciones | Museos | Literatura

 Forum

Contribuciones en el Foro acerca de este modelo: DuMont Labs, Allen B: 1120

Hilos: 2 | Mensajes: 6

I'm preparing to restore the circuit of a Dumont 1120.  I noticed that the measured resistances for couplet were far off.  The 470K resistor between pin 5 and pin7 measured 1.8M ohms.  The other 470K resistor between pin 6 and pin 4 measured 5.5M ohms.  And the 10Meg resistor between Pin 1 and Pin4 measured 16.5M ohms.

Is it common for these to fail?  I just had to rebuild one on a Sylvania R518 couplet.

Schematic included by DR

 

 

 

 

 

 

 

Anexos

Jay Graven, 01.Oct.21

Weitere Posts (3) zu diesem Thema.

 Restoring a Dumont 1120 clock radio.  Unfortunately all four screw posts have broken away from the cabinet.  I still have the broken posts attached to the screws.  Anyone know a good way to reglue the broken posts back to the cabinet?  Will JB Weld work??

Jay Graven, 27.Sep.21

Weitere Posts (3) zu diesem Thema.