U4B Ch= U4B
Emerson Radio & Phonograph Corp.; New York, NY
- Pays
- Etats-Unis
- Fabricant / Marque
- Emerson Radio & Phonograph Corp.; New York, NY
- Année
- 1936 ?
- Catégorie
- Radio - ou tuner d'après la guerre 1939-45
- Radiomuseum.org ID
- 38282
-
- alternative name: Emerson Television
Cliquez sur la vignette du schéma pour le demander en tant que document gratuit.
- No. de tubes
- 4
- Principe général
- Récepteur TRF - sans réaction (pas régénératif)
- Circuits accordés
- 2 Circuits MA (AM)
- Gammes d'ondes
- PO uniquement
- Tension / type courant
- Appareil tous courants (CA / CC) / 110 Volt
- Haut-parleur
- HP dynamique à électro-aimant (électrodynamique) / Ø 5 inch = 12.7 cm
- Matière
- Boitier en bois
- De Radiomuseum.org
- Modèle: U4B Ch= U4B - Emerson Radio & Phonograph
- Forme
- Modèle de table sans poussoirs, modèle cheminée
- Dimensions (LHP)
- 10.5 x 7.5 x 6 inch / 267 x 191 x 152 mm
- Remarques
- This model is named like its chassis. The chassis is also used in models 118, 120, 126. Stein dates it ca 1937, which is too late, since it is already in Riders 7 from 1936/37.
- Poids net
- 3.2 kg / 7 lb 0.8 oz (7.048 lb)
- Source extérieure
- Ernst Erb
- Source du schéma
- Rider's Perpetual, Volume 7 = 1936 and before
- Littérature
- Table Top Radios Vol. 1 Stein 98
- D'autres Modèles
-
Vous pourrez trouver sous ce lien 2086 modèles d'appareils, 1148 avec des images et 1642 avec des schémas.
Tous les appareils de Emerson Radio & Phonograph Corp.; New York, NY
Collections
Le modèle U4B fait partie des collections des membres suivants.
Contributions du forum pour ce modèle: Emerson Radio &: U4B Ch= U4B
Discussions: 1 | Publications: 2
I have this small Table top Emerson U4B in my collection. It was made in 1935 (according to the info in Steins Volume 1 on page 93) According to Stein's, it is an Ingraham cabinet too. It has 4 vacuum tubes + a ballast. The tubes are: 6D6, 6C6, 43, & a 25Z5. It's size is 10.5 " wide by 7.5 " high and 6 " deep ( + knobs ) . It weighs 7 pounds. Has a 5" diameter speaker with a field coil too.
Because of my lack of a new ballast, I had to modify the power supply to get it operating correctly. I now have this set completley restored & operating fine too. I do have 2 pictures of my set that I can upload when you modify the information on this model.
Marvin J. Glassman, 15.Jul.07