Herald RP10
Hacker Radio Ltd., Maidenhead
- País
- Gran Bretaña (GB)
- Fabricante / Marca
- Hacker Radio Ltd., Maidenhead
- Año
- 1960–1963
- Categoría
- Radio - o Sintonizador pasado WW2
- Radiomuseum.org ID
- 79491
Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.
- Numero de transistores
- 7
- Semiconductores
- Principio principal
- Superheterodino en general; ZF/IF 470 kHz
- Gama de ondas
- OM y OL
- Tensión de funcionamiento
- Pilas / 2 x 9 Volt
- Altavoz
- Altavoz elíptico de imán permanente. / Ø 8 inch = 20.3 cm
- Potencia de salida
- 1 W (unknown quality)
- Material
- Cuero/Tela/ Plástico sobre otros materiales
- de Radiomuseum.org
- Modelo: Herald RP10 - Hacker Radio Ltd., Maidenhead
- Forma
- Portátil > 20 cm (sin la necesidad de una red)
- Ancho, altura, profundidad
- 12 x 8.5 x 4.5 inch / 305 x 216 x 114 mm
- Anotaciones
-
The Herald seven-transistor portable receiver. Interesting features of this are a specially-loaded large (8" x 5") loudspeaker, a one-watt push-pull output, and three-position tone control.
Sockets are provided for an external aerial for use in a car and for connecting a microphone for using the receiver as a Baby Alarm.Up to s/n 20000 Ediswan transistors fitted.
April 1962 s/n 20001 onwards chassis revised, Transistors: 3 x AF117, OC71, OC81D 2 x OC81.
- Peso neto
- 2 kg / 4 lb 6.5 oz (4.405 lb)
- Mencionado en
- Wireless World (The), London (WW, 79) (Sep 1960, Page 442.)
- Documentación / Esquemas (1)
- -- Original-techn. papers.
- Autor
- Modelo creado por Juan Antonio Pardo-Alonso. Ver en "Modificar Ficha" los participantes posteriores.
- Otros modelos
-
Donde encontrará 56 modelos, 56 con imágenes y 23 con esquemas.
Ir al listado general de Hacker Radio Ltd., Maidenhead
Colecciones
El modelo Herald es parte de las colecciones de los siguientes miembros.
Contribuciones en el Foro acerca de este modelo: Hacker Radio Ltd.,: Herald RP10
Hilos: 1 | Mensajes: 1
Hi can you tell me where the 6 pins from the amp board go to I'm attempting to use the amp from a RP10 to repair a RP 38a I know the position on the RP38 (their printed on the board) but on the RP10 there's only numbers 1 to 6
Eddie Stevenson, 04.Aug.20