• Paese
• Australia

• Produttore / Marca
• Kriesler Radio Company; Newtown (Sydney)

• Anno
• 1946–1948

• Categoria
• Radio (o sintonizzatore del dopoguerra WW2)

• Radiomuseum.org ID
• 88434

Clicca sulla miniatura dello schema per richiederlo come documento gratuito.

• Numero di tubi
• 4

• Valvole
• 6J8G 6G8G 6V6GT 5Y3G

• Principio generale
• Supereterodina (in generale); ZF/IF 455 kHz; 2 Stadi BF; Reflex

• N. di circuiti accordati
• 6 Circuiti Mod. Amp. (AM)

• Gamme d'onda
• Onde medie (OM) e corte (OC).

• Tensioni di funzionamento
• Alimentazione a corrente alternata (CA) / 220; 240 Volt

• Altoparlante
• AP elettrodinamico (bobina mobile e bobina di eccitazione/di campo) / Ø 5 inch = 12.7 cm

• Materiali
• Bachelite

• Radiomuseum.org
• Modello: Beehive 11-4A Ch= 11-4 - Kriesler Radio Company;

• Forma
• Soprammobile compatto/con bordi arrotondati/midget senza pulsantiera/tastiera.<= 35 cm (Sometimes with handle but for mains only).

• Dimensioni (LxAxP)
• 250 x 220 x 210 mm / 9.8 x 8.7 x 8.3 inch

• Annotazioni

• Kriesler advertised this set & other post-war models as a "Sealed Radio". Solder joints were marked to prevent unauthorised servicing & tampering.

  Walnut Bakelite cabinet. Also available in various colours for 1 Guinea (£1/1/-) extra. Price in WA for standard Walnut model, £19/8/6.

  There are 36 variants of this model:

  • CIRCUIT: As on 11-4 circuit. (Diagram in lower right hand corner of sheet does not apply)
  • COIL KIT: Part No. 15-2 (S.C. Tuning Condenser).
  • DIAL GLASSES: Part No. 50-2 (Local stations). Part No. 50-1 (Country stations).
  • SPEAKER: Part No. 70-1 (5" Electro dynamic).
  • OUTPUT TRANSFORMER: Part No. 18-28.
  • POWER TRANSFORMER: Part No. 18-27 (H.T.: 325v. each side of centre tap).

  PROCEDURE FOR REMOVING CHASSIS FROM CABINET:

  1. Remove knobs.
  2. Invert receiver.
  3. Remove base by breaking seal and unscrewing 4 x 3/16" screws in base of cabinet.
  4. Remove 4 x 3/16" nuts, situated in the inside corners of the chassis.
  5. Lay receiver on its back with spindles facing upwards.
  6. Place one hand each side the of chassis. With the forefingers, exert a downward pressure on the front panel, at the same time withdrawing the chassis from the cabinet.

  CHASSIS NUMBERS:

  Every receiver that leaves the Kriesler factory is given two chassis numbers.

  The "Production" chassis number is stamped on a card. The card is riveted to the main chassis in such a location that the number is able to be read without removing the chassis from the cabinet. The "Production" chassis number is the number that should be quoted, together with the model number, when making enquiries.

  The second chassis number (Prefix "0") is stamped into the metal chassis to provide a permanent record.

  Both the abovementioned chassis numbers are recorded at the factory.

   

• Prezzo nel primo anno
• 18.90 AUS £

• Riferimenti schemi
• Australian Official Radio Service Manual Vol. V

• Letteratura / Schemi (1)
• - - Manufacturers Literature (Kriesler Technical Service Instructions.)

• Letteratura / Schemi (2)
• Australian Official Radio Service Manual AORSM (Volume 5, 1947, Page 188 & Volume 6, 1948, Page 262.)

Kriesler Beehive 11-4 Technical Service Instructions

928 KB

• Documenti su questo modello

• Autore
• Modello inviato da Peter Hughes. Utilizzare "Proponi modifica" per inviare ulteriori dati.

• Altri modelli

• In questo link sono elencati 895 modelli, di cui 440 con immagini e 435 con schemi.
  Elenco delle radio e altri apparecchi della Kriesler Radio Company; Newtown (Sydney)