Beehive 11-4GZ

Kriesler Radio Company; Newtown (Sydney)

Dati
Forum
Immagini
Collezioni

  • Anno
  • 1946–1948
  • Categoria
  • Radio (o sintonizzatore del dopoguerra WW2)
  • Radiomuseum.org ID
  • 297588

Clicca sulla miniatura dello schema per richiederlo come documento gratuito.

 Specifiche tecniche

  • Numero di tubi
  • 4
  • Principio generale
  • Supereterodina (in generale); ZF/IF 455 kHz; Reflex
  • Gamme d'onda
  • Onde medie (OM) e corte (OC).
  • Tensioni di funzionamento
  • Alimentazione a corrente alternata (CA) / 220-240 Volt
  • Altoparlante
  • AP magnetodinamico (magnete permanente e bobina mobile)
  • Materiali
  • Bachelite
  • Radiomuseum.org
  • Modello: Beehive 11-4GZ - Kriesler Radio Company;
  • Forma
  • Soprammobile compatto/con bordi arrotondati/midget senza pulsantiera/tastiera.<= 35 cm (Sometimes with handle but for mains only).
  • Annotazioni

  • Kriesler advertised this set & other post-war models as a "Sealed Radio". Solder joints were marked to prevent unauthorised servicing & tampering.

    Walnut Bakelite cabinet. Also available in various colours for 1 Guinea (£1/1/-) extra. Price in WA for standard Walnut model, £19/8/6.

    There are 36 variants of this model:

    • CIRCUIT: As on 11-4 circuit but with the following alterations:- (Note: Enclosed diagram in lower right hand corner of sheet does not apply).
    1. Tone control (0.5 Megohm Potentiometer) replaced by 2 position, 0.02 μF 600v. condenser (C95) and 0.5 Megohm ½ watt resistor (R117). Disconnect lead from centre lug of potentiometer, and wire it to stationary contact of switch. Earth moving arm of switch. Replace potentiometer with fixed resistor.
    2. Speaker 70-1 was replaced by speaker 70-8.
    3. H.T. choke (28-3) to replace field of 70-1 speaker.
    4. 6J8G valve replaced by EK32 converter.
    5. Remove lead connecting 6J8G screen to 6G8G, wire 0.05 μF 200v. (C21B) from EK32 screen (pin No. 4) to ground. Wiore 0.05 Megohm (R14) from 6G8G screen to B+, replace 0.03 Megohm (R136) with 0.015 Megohm (R140).
    6. Power transformer 18-27 changed to 18-32.
    7. 5Y3G valve replaced by 6X5GT rectifier, (6X5GT heater connected to 6.3v winding on transformer).
    • COIL KIT: Part No. 15-2 (S.C. Tuning Condenser).
    • DIAL GLASSES: Part No. 50-12 (Principle section). Part No. 50-25 (Rear glass).
    • SPEAKER: Part No. 70-8 (5" Permanent magnet type).
    • OUTPUT TRANSFORMER: Part No. 18-26.
    • POWER TRANSFORMER: Part No. 18-32 (H.T.: 250v each side of centre tap).
    • NOTE: Power transformers 18-32 & 18-6 are interchangable. When 18-32 is used a 400 Ω bias resistor is used. When 18-6 is used a 250 Ω bias resistor is used.
  • Prezzo nel primo anno
  • 18.90 AUS £
  • Letteratura / Schemi (1)
  • - - Manufacturers Literature (Kriesler Technical Service Instructions.)
  • Autore
  • Modello inviato da Martin Kent. Utilizzare "Proponi modifica" per inviare ulteriori dati.

 Collezioni | Musei | Letteratura

 Forum