• Jahr
  • 1919–1922
  • Kategorie
  • Detektorempfänger (Kristall oder Diode, ohne Röhre/Transistoren) 
  • Radiomuseum.org ID
  • 199179
    • Marke: Musaphonic

 Technische Daten

  • Hauptprinzip
  • Detektion ohne aktive Elemente, solid state
  • Wellenbereiche
  • Langwelle, Mittelwelle (LW+MW).
  • Betriebsart / Volt
  • Keine Stromversorgung
  • Lautsprecher
  • - Für Kopfhörer oder NF-Verstärker
  • Material
  • Gerät mit Holzgehäuse
  • von Radiomuseum.org
  • Modell: Radio Receiver 106D - General Electric Co. GE;
  • Form
  • Tischgerät, Truhenform, meist mit Deckel (NICHT Schrägpult).
  • Abmessungen (BHT)
  • 21 x 12 x 9.5 inch / 533 x 305 x 241 mm
  • Bemerkung
  • In 1919 the Marconi Wireless Telegraph Co. was absorbed into the RCA conglomerate and prduction of the 106B was transfered to the GE plant in Schenectady, New York. Sets built after the merger no longer had Marconi Wireless engraved on the front panels. Instead all subsequent sets had Radio Corporation of America by General Electric Co. U.S.A. engraved on the front panel. 

    Towards the end of 1922 GE introduced a conversion kit to convert earlier 106 models into a regenerative 106D model using an external tube detector. The new added tickler coil, along with the output, was brought out to a new terminal strip on the RH side of the cabinet. The track and gear loose coupled secondary was completely replaced by an entirely new assembly with the coupling coil hinged over the vertically mounted secondary coil. It still covered the same 200-3500 meters wavelength range that the earlier non-regenerative 106 models did.

    Another new change to the 106 was the addition of a phone jack in the lower RH corner for operator headphones. The phone jack was installed in the buzzer button hole on the 106 and a new whole was drilled in the panel of 106B and 106C receivers. This phone jack matched the phone jack on the front panels of the GE AD-1527, AA-1528 and AA-1400 units with which the 106D was also used. The new phone jack allowed the operator to switch between the crystal detector and the external vacuum tube detector without using binding posts. 

    Three new pairs of binding posts were also added to the top of the front panel. These new pairs were connected to the primary, secondary and tickler circuits and were used in conjuntion with external loading coils. This allowed the 106D to communicate with transoceanic stations such as RCA;s WQL which operated at a wavelength of 16,465 meters.

    The 106D conversions were available at the factory but most were performed in the field using the factory supplied conversion kit. 

  • Nettogewicht
  • 12.8 kg / 28 lb 3.1 oz (28.194 lb)
  • Autor
  • Modellseite von Alan Larsen angelegt. Siehe bei "Änderungsvorschlag" für weitere Mitarbeit.

 Sammlungen | Museen | Literatur

Sammlungen

Das Modell Radio Receiver befindet sich in den Sammlungen folgender Mitglieder.

Museen

Das Modell Radio Receiver ist in den folgenden Museen zu sehen.

 Forum