Monitor Series Power Amplifier 2100 Power Envelope

NAD, New Acoustic Dimension; Ontario

  • Jahr
  • 1988 ?
  • Kategorie
  • NF-(Niederfrequenz-) Verstärker oder -Mixer
  • Radiomuseum.org ID
  • 310184

 Technische Daten

  • Anzahl Transistoren
  • Halbleiter vorhanden.
  • Halbleiter
  • Hauptprinzip
  • NF-Verstärkung
  • Wellenbereiche
  • - ohne
  • Spezialitäten
  • Hi-Fi-Gerät
  • Betriebsart / Volt
  • Wechselstromspeisung / 110 or 120 or 220 or 240 Volt
  • Lautsprecher
  • - Dieses Modell benötigt externe(n) Lautsprecher.
  • Belastbarkeit / Leistung
  • 100 W (140 W max./spitze)
  • Material
  • Metallausführung
  • von Radiomuseum.org
  • Modell: Monitor Series Power Amplifier 2100 Power Envelope - NAD, New Acoustic Dimension;
  • Form
  • Regalgerät wie HiFi-Komponente für Bücherwand.
  • Abmessungen (BHT)
  • 435 x 108 x 381 mm / 17.1 x 4.3 x 15 inch
  • Bemerkung
  • A 2 x 50 watt (150 watt Bridged Mono) hi-fi stereo Power Amplifier in NAD's Monitor Series of hi-fi separates. With a high-voltage, high-current output stage enabling it to deliver well above its rated power to handle musical transients, and a 'soft clipping' circuit which gently limits the waveform voltage when the amplifier is driven beyond its rated power.

    On the rear, Normal-In and Lab-in sockets for connection to a pre-amplifier, (Lab-in has a wideband frequency response), switches for Input (Normal or Lab), Soft Clipping (On/Off), Bridging (On/Off), and a Speakers Impedance switch (Normal 4Ω / Hi 8Ω), (the Hi setting can be used where one pair of speakers are connected and impedance is at least 8Ω, this re-optimizes the amplifier for maximum power). Some models have a switched and an unswitched AC outlet.

    On the front, push button for Power, Speakers A, B, rotary controls for Left/Mono and Right Input Level, LED indicators for Power, Protection and Soft Clipping and a jack for headphones.

    Specification
    Stereo Mode

    Continuous Average Power Output into
      8 ohm (Min, RMS power per channel
      20-20kHz both Channels Driven
      with no more than rated distortion) .......:  50 W
    Rated Distortion  20Hz-20kHz ...............:  0.03%
    Clipping Power (Maximum continuous....:  70 W
                            power per channel)
    IHF Dynamic Headroom at 8 ohm .........:  +6dB
    IHF Dynamic Power at 8 ohm ...............:  200 W
      (Short term power) at 4 ohm ...............:  250 W
                                  at 2 ohm ...............:  330 W
    Damping Factor at 50 Hz (Ref. 8 ohm) ..:  100
    THD 20Hz-20kHz from 250mW to rated  :  <0.03%
    Frequency Response, Lab input ...........:  3Hz - 100kHz, +0db -3dB
    Signal to Noise Ratio A-weighted .........: 100db ref 1W, 117dB at rated power

    Bridged (Monophonic) Mode
    Continuous Average Power Output into
      8 ohm (Min, RMS power per channel
      20-20kHz both Channels Driven
      with no more than rated distortion) ......:  150 W
    IHF Dynamic Headroom at 8 ohm .........:  +6dB
    IHF Dynamic Power at 8 ohm (max.......:  500 W
     (Short term power)  at 4 ohm ...............:  660 W

    Versions/Power Requirements
    110 or 120 V AC 60Hz
    220 or 240 V AC 50Hz

    Made in Taiwan

  • Nettogewicht
  • 9.520 kg / 20 lb 15.5 oz (20.969 lb)
  • Literatur/Schema (1)
  • - - Manufacturers Literature (NAD Service manual for the 2100 power amplifier)
  • Autor
  • Modellseite von Howard Craven angelegt. Siehe bei "Änderungsvorschlag" für weitere Mitarbeit.

 Sammlungen | Museen | Literatur

 Forum