Skipper 196

Philips Australia

  • Année
  • 1958–1960
  • Catégorie
  • Radio - ou tuner d'après la guerre 1939-45
  • Radiomuseum.org ID
  • 227213

Cliquez sur la vignette du schéma pour le demander en tant que document gratuit.

 Spécifications techniques

  • No. de tubes
  • 4
  • Principe général
  • Super hétérodyne (en général); FI/IF 455 kHz
  • Gammes d'ondes
  • PO uniquement
  • Tension / type courant
  • Secteur et Piles (tous types). / 200 - 250 / 7.5 & 90 Volt
  • Haut-parleur
  • HP dynamique à aimant permanent + bobine mobile / Ø 4 inch = 10.2 cm
  • Matière
  • Cuir / canvas / plastique mais autre matériel en dessous!
  • De Radiomuseum.org
  • Modèle: Skipper 196 - Philips Australia
  • Forme
  • Portative > 20 cm (sans nécessité secteur)
  • Dimensions (LHP)
  • 280 x 180 x 120 mm / 11 x 7.1 x 4.7 inch
  • Remarques
  • This radio is a valve portable, made when transistor portables were coming onto the Australian market. Many manufacturers at this stage produced both valve and transistor models to try for full market coverage. It is similar in styling to the (transistor) 199/199C but has no tone control. Mains power is through a 2 pin plug on the side of the radio.

    Batteries needed were a 7.5 volt "A" battery (No 717 or 3717) and a 90 volt "B" battery (No 490P or 3490P). The paperwork inside the case says that the radio "Incorporates automatic "B" battery recharging." but the method is in the "Instruction Book"

    Mains rectification is by a half wave Selenium Rectifier and filament voltage is derived from the HT by dropping resistors.

    There is a switch for selecting mains or battery power or OFF under the handle connector on one side of the radio. This switch is brass and apart from this, the radio would probably qualify as "Double Insulated" by modern standards.

    A protector plate was installed between the batteries and the under-chassis components.

    See also similar model 196A & Fleetwood model FL6000.

    Colours available in Champagne, Cherry & Grey.

     

     

  • Poids net
  • 4 lb 7 oz (4.438 lb) / 2.015 kg
  • Prix de mise sur le marché
  • 33.60 AUS £
  • Littérature
  • Silicon Chip Magazine (Australia) April 2012 P82ff
  • Schémathèque (1)
  • - - Manufacturers Literature (Philips Radioplayer Service Data, October 1958.)
  • Auteur
  • Modèle crée par Brian Wilson. Voir les propositions de modification pour les contributeurs supplémentaires.

 Collections | Musées | Littérature

Collections

Le modèle Skipper fait partie des collections des membres suivants.

 Forum