Skipper 196

Philips Australia

  • Año
  • 1958–1960
  • Categoría
  • Radio - o Sintonizador pasado WW2
  • Radiomuseum.org ID
  • 227213

Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.

 Especificaciones técnicas

  • Numero de valvulas
  • 4
  • Principio principal
  • Superheterodino en general; ZF/IF 455 kHz
  • Gama de ondas
  • OM (onda media) solamente
  • Tensión de funcionamiento
  • Red / Baterías o pilas / 200 - 250 / 7.5 & 90 Volt
  • Altavoz
  • Altavoz dinámico (de imán permanente) / Ø 4 inch = 10.2 cm
  • Material
  • Cuero/Tela/ Plástico sobre otros materiales
  • de Radiomuseum.org
  • Modelo: Skipper 196 - Philips Australia
  • Forma
  • Portátil > 20 cm (sin la necesidad de una red)
  • Ancho, altura, profundidad
  • 280 x 180 x 120 mm / 11 x 7.1 x 4.7 inch
  • Anotaciones
  • This radio is a valve portable, made when transistor portables were coming onto the Australian market. Many manufacturers at this stage produced both valve and transistor models to try for full market coverage. It is similar in styling to the (transistor) 199/199C but has no tone control. Mains power is through a 2 pin plug on the side of the radio.

    Batteries needed were a 7.5 volt "A" battery (No 717 or 3717) and a 90 volt "B" battery (No 490P or 3490P). The paperwork inside the case says that the radio "Incorporates automatic "B" battery recharging." but the method is in the "Instruction Book"

    Mains rectification is by a half wave Selenium Rectifier and filament voltage is derived from the HT by dropping resistors.

    There is a switch for selecting mains or battery power or OFF under the handle connector on one side of the radio. This switch is brass and apart from this, the radio would probably qualify as "Double Insulated" by modern standards.

    A protector plate was installed between the batteries and the under-chassis components.

    See also similar model 196A & Fleetwood model FL6000.

    Colours available in Champagne, Cherry & Grey.

     

     

  • Peso neto
  • 4 lb 7 oz (4.438 lb) / 2.015 kg
  • Precio durante el primer año
  • 33.60 AUS £
  • Mencionado en
  • Silicon Chip Magazine (Australia) April 2012 P82ff
  • Documentación / Esquemas (1)
  • - - Manufacturers Literature (Philips Radioplayer Service Data, October 1958.)
  • Autor
  • Modelo creado por Brian Wilson. Ver en "Modificar Ficha" los participantes posteriores.

 Colecciones | Museos | Literatura

Colecciones

El modelo Skipper es parte de las colecciones de los siguientes miembros.

 Forum