- País
- Holanda
- Fabricante / Marca
- Philips; Eindhoven (tubes international!); Miniwatt
- Año
- 1958–1961
- Categoría
- Registrador o reproductor de sonido o visual
- Radiomuseum.org ID
- 161110
- Gama de ondas
- - no hay
- Especialidades
- Tocadiscos (sin cambiador autom)
- Tensión de funcionamiento
- Red: Corriente alterna (CA, Inglés = AC) / 110; 127; 220 Volt
- Altavoz
- - Este modelo usa amplificador externo de B.F.
- Material
- Inyectado (se desconoce si bakelita o plástico).
- de Radiomuseum.org
- Modelo: AG2210/95 - Philips; Eindhoven tubes
- Forma
- Sobremesa de cualquier forma, detalles no conocidos.
- Ancho, altura, profundidad
- 345 x 130 x 255 mm / 13.6 x 5.1 x 10 inch
- Anotaciones
- 4 speed record player. Automatic switch-off based on arm travel per revolution. Speed regulation with magnetic brake on motor spindle.
Intermediate wheel retracted on switch-off.
Arm lift with separate lever. Needle pressure can be set with dial on the arm hinge.
Black part of housing is Bakelite, top cover is grey and made of modern plastics (moulded)
- Precio durante el primer año
- 135.00 CHF
- Procedencia de los datos
- -- Original prospect or advert
- Autor
- Modelo creado por Wouter Nieuwlaat † 27.5.18. Ver en "Modificar Ficha" los participantes posteriores.
- Otros modelos
-
Donde encontrará 5233 modelos, 4365 con imágenes y 3446 con esquemas.
Ir al listado general de Philips; Eindhoven (tubes international!); Miniwatt
Colecciones
El modelo es parte de las colecciones de los siguientes miembros.
Contribuciones en el Foro acerca de este modelo: Philips; Eindhoven: AG2210/95
Hilos: 1 | Mensajes: 1
When I acquired this record player, it would jump out of the groove when reaching the end of the record.
It turned out this was caused by the automatic switch-off function. The lever comes in very early, but is pushed back as long as the needle travels only a small way per revolution (still in the normal playing track). This lever was stuck, and it made the needle skip grooves ones it started touching.
To dismantle the mechanism you have to lift the rubber cover, and find a small hole in the turntable.
turn the table so that the hole is closest to the Philips brand name. Press with a medium/long screwdriver that is put straight down into the hole, and lift the turntable at the same time
Now you can access the intermediate wheel and motor spindle.
To remove the mechanism from the bottom half of the housing, you need to unscrew the sprung feet. There is no mounting screw in the middle, just grab the entire foot and turn anticlockwise!
Wouter Nieuwlaat † 27.5.18, 15.Sep.09