Communications Receiver AR7030
AOR Manufacturing Ltd.; Matlock, England
- País
- Gran Bretaña (GB)
- Fabricante / Marca
- AOR Manufacturing Ltd.; Matlock, England
- Año
- 1996–2008
- Categoría
- Receptor para radioaficionados (puede incluir bandas de radiodifusión publ.)
- Radiomuseum.org ID
- 287363
Quelle: ebay.de, #322371919485
Quelle: ebay.de, #332038784273
- Numero de transistores
- Hay semiconductores.
- Semiconductores
- Principio principal
- Superheterodino doble o triple conversión; ZF/IF 45000/455 kHz
- Gama de ondas
- OM, OL y OC
- Especialidades
- Radio Control (+Remote Wire etc)
- Tensión de funcionamiento
- Alimentado desde otro equipo o aparato principal. / 500 ma @ 15 DC Volt
- Altavoz
- Altavoz dinámico (de imán permanente)
- Potencia de salida
- 1.8 W (undistorted)
- Material
- Metálico
- de Radiomuseum.org
- Modelo: Communications Receiver AR7030 - AOR Manufacturing Ltd.;
- Forma
- Sobremesa de cualquier forma, detalles no conocidos.
- Ancho, altura, profundidad
- 9.45 x 3.54 x 10 inch / 240 x 90 x 254 mm
- Anotaciones
-
The AOR AR7030 is a general coverage communications receiver, covering 0-32 MHz. It receives in AM, LSB, USB, CW, FM and FSK modes. Also see the AOR AR7030 Plus.
- Peso neto
- 4.9 lb (4 lb 14.4 oz) / 2.225 kg
- Mencionado en
- Shortwave Receivers - Past & Present (4th ed.) (page 71)
- Autor
- Modelo creado por Wayne Childress. Ver en "Modificar Ficha" los participantes posteriores.
- Otros modelos
-
Donde encontrará 3 modelos, 3 con imágenes y 1 con esquemas.
Ir al listado general de AOR Manufacturing Ltd.; Matlock, England
Contribuciones en el Foro acerca de este modelo: AOR Manufacturing: Communications Receiver AR7030
Hilos: 1 | Mensajes: 1
My AR7030 surprised me with a strange malfunction: from time to time, a strange peeping noise, the panel goes blank, the receiver stops working …
Checking the reason for the apparent short-circuit leads to the ‚+10db‘ position of the RF-IF button and the reason seems obvious, Q16.
De-soldering the transistor solves the short-circuit problem, but following this operation the receiver delivers static only on any AM signal but normal reception on the sidebands, FM and CW.
Measuring the usual suspects gets you nowhere – everything seems to be ok until you reach the 2nd mixer, but the IF amp has no input signal. The apparent culprits could well be the 4053 switching circuits and/or Q83, a 4094 controling the swichting ICs.
When faced with an SMD cemetary one hesitates to de-solder more ICs than absolutely necessary … which leads to a prolonged phase of thinking things over.
In the end it was, as it most often is the case, the simplest thing. Probably caused by the short, the memory ‚forgot‘ its filter bank config and a reset plus a new filter calibration made it remember again it had an AM filter.
As I never used the +10db RF gain position I just left Q16 out and we’re happily living together again, my 7030 and I.
Hubert Eisner, 25.Jan.20