- Land
- USA
- Hersteller / Marke
- Crosley Radio Corp.; Cincinnati (OH)
- Jahr
- 1924
- Kategorie
- Rundfunkempfänger (Radio - oder Tuner nach WW2)
- Radiomuseum.org ID
- 36676
Klicken Sie auf den Schaltplanausschnitt, um diesen kostenlos als Dokument anzufordern.
- Anzahl Röhren
- 3
- Röhren
- Hauptprinzip
- Geradeaus oder Audion mit Rückkopplung
- Betriebsart / Volt
- Akku und/oder Batterie
- Lautsprecher
- - Für Kopfhörer oder NF-Verstärker
- Material
- Gerät mit Holzgehäuse
- von Radiomuseum.org
- Modell: 52 - Crosley Radio Corp.;
- Form
- Tischgerät, Truhenform, meist mit Deckel (NICHT Schrägpult).
- Abmessungen (BHT)
- 13.8 x 6 x 8 inch / 351 x 152 x 203 mm
- Bemerkung
- One dial (primary tuning control knob)
- Originalpreis
- 30.00 $
- Datenherkunft extern
- Ernst Erb
- Datenherkunft
- Radio Collector`s Guide 1921-1932
- Literaturnachweis
- Collector's Guide to Antique Radios 4. Edition
- Literatur/Schema (2)
- Radio Broadcast, Apr. 1925, p. 1134
- Weitere Modelle
-
Hier finden Sie 1812 Modelle, davon 1050 mit Bildern und 1306 mit Schaltbildern.
Alle gelisteten Radios usw. von Crosley Radio Corp.; Cincinnati (OH)
Sammlungen
Das Modell 52 befindet sich in den Sammlungen folgender Mitglieder.
Forumsbeiträge zum Modell: Crosley Radio Corp.;: 52
Threads: 2 | Posts: 4
The Crosley 52 Operating Instructions ( at crosleyradios.com) explain that two 45 volt B batteries are required, with the +45V terminal on the second battery connected to the B45+ terminal on the radio. With the two 45 volt batteries connected in series, there is actually +90 volts at this terminal with respect to B-, so the modern schematic currently shown here should be corrected to show 90 volts, rather than 48 volts, connecting through the speaker to the output tube's plate. The instructions explain that low volume will be heard if 90 volts is not used.
Also, as explained in the instructions, the Crosley 52 came from the factory with an internal wire connecting the A- and C- terminals together. There is no mention of using a C battery, or connecting anything to the C- binding post, when using 01A tubes. But, it may be beneficial to use a C battery if using WD12 or UV199 tubes and in those cases the internal wire must be cut before connecting power to the C- binding post.
Regards, Greg Farmer
Greg Farmer, 03.Jun.22
Good Luck,
Paul P
Paul E. Pinyot † 2013, 17.Aug.05