U1040

Ferranti, GB

Données
Forum
Images
Collections

  • Année
  • 1961 ?
  • Catégorie
  • Radio - ou tuner d'après la guerre 1939-45
  • Radiomuseum.org ID
  • 151934

Cliquez sur la vignette du schéma pour le demander en tant que document gratuit.

 Spécifications techniques

  • No. de tubes
  • 7
  • Principe général
  • Super hétérodyne (en général); FI/IF 470/10700 kHz; 2 Etage(s) BF
  • Circuits accordés
  • 6 Circuits MA (AM)     8 Circuits MF (FM)
  • Gammes d'ondes
  • PO, GO et FM
  • Tension / type courant
  • Appareil tous courants (CA / CC) / 200-250 Volt
  • Haut-parleur
  • HP dynamique à aimant permanent + bobine mobile
  • De Radiomuseum.org
  • Modèle: U1040 - Ferranti, GB
  • Remarques
  • Same chassis as model U1032.
  • Source
  • -- Schematic
  • Source du schéma
  • Radio and TV Servicing books (R&TVS) book
  • Auteur
  • Modèle crée par Keith Staines. Voir les propositions de modification pour les contributeurs supplémentaires.

 Collections | Musées | Littérature

 Forum

Contributions du forum pour ce modèle: Ferranti, GB: U1040

Discussions: 1 | Publications: 6

To any potential RMorg helpers,

                                             I have just started some restoration work on a Ferranti U1040 which after some valve/tube replacement, is operating fairly well.

In order to try to rectify some distoration & intermittent sound loss, I have removed the chassis, and attached  a couple of pictures of what I have found - despite working fairly well, there are the remains of what I think is a 0.01uf capacitor, which has the original wire connector at one end still soldered as can be seen.

I have tried for about an hour to see where the other end was attached, without success; perhaps the other end of the capacitor has been blown out of the radio somehow, I certainly can`t find it.

As far as I can see from the schematic, there are 3 such cpacitors fitted, and I have found the other two.

In order to replace these 3  `wax, caps`, I need to find out which capacitor it is that has blown, and where it should be connected within the chassis; apart from the one connection I still have (which is connected to the chassis itself). I cannot find a chassis layout in amongst all my sources.

Can anyone help me with this cap replacement please - this is a fairly good looking radio, and even without the blown cap operates adequately enough, but has the potential to work even better.

 

Thanks in advance for any assistance anyone can provide.

 

graham guy

Pièces jointes

Graham GUY, 07.Jul.11

Weitere Posts (6) zu diesem Thema.