Quartz-Locked Direct-Drive Turntable QL-A2

JVC - Victor Company of Japan, Ltd.; Tokyo

  • Año
  • 1978
  • Categoría
  • Registrador o reproductor de sonido o visual
  • Radiomuseum.org ID
  • 296788

 Especificaciones técnicas

  • Gama de ondas
  • - no hay
  • Especialidades
  • Tocadiscos (sin cambiador autom)
  • Tensión de funcionamiento
  • Red: Corriente alterna (CA, Inglés = AC) / 110-240 Volt
  • Altavoz
  • - Este modelo usa amplificador externo de B.F.
  • Material
  • Inyectado (se desconoce si bakelita o plástico).
  • de Radiomuseum.org
  • Modelo: Quartz-Locked Direct-Drive Turntable QL-A2 - JVC - Victor Company of Japan,
  • Forma
  • Sobremesa apaisado (tamaño grande).
  • Ancho, altura, profundidad
  • 460 x 147 x 365 mm / 18.1 x 5.8 x 14.4 inch
  • Anotaciones
  • Halbautomatischer Plattenspieler mit Plexiglashaube, Geschwindigkeitem 45/33 Upm, Tonarmrückführung und Abschaltung. Tonabnehmersystem MD-1025 mit Nadel DT-Z1S Diamant, Auflagegewicht 2 Gramm.

    Reparaturhilfe:

    Bei diesem Gerät ist ein oftmals auftretenden Fehler dass keine Synchronisation bei 33 Upm möglich ist. Neben das Reinigen des 45/33 Upm-Schalters gibt es die Möglichkeit eines scheinbar fehlerhaften IC802 (SM 6415A-4S von NPC) wieder zu beleben. 
    Eingangspin 12 (Schalten des 20- oder 27-Teilers auf 27) sollte bei 33 Upm nahezu auf 0 Volt zurückfallen. Falls dies nicht der Fall ist gibt ein Pulldown-Widerstand von 820 Ohm nach Ground Aushilfe. Man kann diesen Widerstand an der Lötseite zwischen Pin 12 und ein Groundpin (z.B. Pin 14) löten. Nach diesen Eingriff funktioniert die Synchronisation auch bei 33 Upm meistens wieder einwandfrei. 

    -----------------------------------------

    Semi-automatic turntable with plexiglass cover, speeds 45/33 rpm, tonearm return and switch-off. Pickup system MD-1025 with needle DT-Z1S Diamond, weight 2 grams.

    Repair hint:

    A common error with this device is that synchronization is not possible at 33 rpm. In addition to cleaning the 45/33 rpm switch, there is the possibility of reviving an apparently faulty IC802 (SM 6415A-4S from NPC).

    Input pin 12 (switching the 20 or 27 dividers to 27) should drop almost to 0 volts at 33 rpm. If this is not the case, a pull-down resistor of 820 ohms to ground will help. You can solder this resistor on the solder side between pin 12 and a ground pin (e.g., pin 14).

    After this intervention, the synchronization usually works perfectly again, even at 33 rpm.

  • Peso neto
  • 6.5 kg / 14 lb 5.1 oz (14.317 lb)
  • Autor
  • Modelo creado por Felix Kreitlow. Ver en "Modificar Ficha" los participantes posteriores.

 Colecciones | Museos | Literatura

Colecciones

El modelo Quartz-Locked Direct-Drive Turntable es parte de las colecciones de los siguientes miembros.

 Forum