• Année
  • 1954/1955
  • Catégorie
  • Radio - ou tuner d'après la guerre 1939-45
  • Radiomuseum.org ID
  • 87102
    • alternative name: Grundig Portugal || Grundig USA / Lextronix

Cliquez sur la vignette du schéma pour le demander en tant que document gratuit.

 Spécifications techniques

  • No. de tubes
  • 5
  • No. de transistors
  • Principe général
  • Super hétérodyne (en général); FI/IF 468 kHz; 2 Etage(s) BF; Modèle pour exporter
  • Circuits accordés
  • 6 Circuits MA (AM)
  • Gammes d'ondes
  • PO et 2 x OC
  • Tension / type courant
  • Alimentation Courant Alternatif (CA) / 110; 125; 150; 220 Volt
  • Haut-parleur
  • HP dynamique à aimant permanent + bobine mobile
  • Matière
  • Boitier en bois
  • De Radiomuseum.org
  • Modèle: 1045W - Grundig Radio-Vertrieb, RVF,
  • Forme
  • Modèle de table avec boutons poussoirs.
  • Dimensions (LHP)
  • 463 x 304 x 215 mm / 18.2 x 12 x 8.5 inch
  • Remarques
  • Exportgerät
    Wellenbereiche:
    MW: 510-1620 kHz
    SW1: 2-6 MHz
    SW2: 6-17 MHz
  • Littérature
  • -- Original prospect or advert
  • Auteur
  • Modèle crée par Carlos A. Pieroni-García. Voir les propositions de modification pour les contributeurs supplémentaires.

 Collections | Musées | Littérature

Collections

Le modèle fait partie des collections des membres suivants.

 Forum

Contributions du forum pour ce modèle: Grundig Radio-: 1045W

Discussions: 1 | Publications: 8

Fellow Radiophiles,

I am making good progress in the restoration of the Grundig 1045 that belonged to Andre de Melo in my youth. His son Fernando owns it now, and my restoration preserves the radio and fond memories with these friends. I remember hearing this radio during the late 1960's, while it played the soccer broadcast in the tavern that Andre owned next to his general store.

After replacing the rotted out power transformer with a replacement that was given to by RMORG member Ross Hochstrasser, and replacing three resistors and the original electrolytics, the radio is working again. I have another couple of weeks while I am in vacation at Furnas in the Azores to check out it's performance. The only weak tubes were the IF and tuning eye, but I replaced all just the same, while keeping the non-original old ones with the radio.

Ross also supplied me with a set of original knobs, which look great on the radio. I cleaned the three front brass pieces with the american Twinkle copper cleaning creme.

I have two questions:

1-What protective finish should I apply to the brass pieces in this very humid climate?

2-How should have remove the speaker cloth for cleaning?

Is the glue a contact type that softens with alcohol or acetone, or is it a wood glue that would soften with white vinegar and water?

Perhaps the cloth can be cleaned in place, but how?

Is there a danger of shrinkage? As seen in this photo, some shrinkage can be tolerated.

Regards,

-Joe

Joe Sousa, 22.Jul.10

Weitere Posts (8) zu diesem Thema.