|
|
||||
Year: 1956–1958 | Category: Broadcast Receiver - or past WW2 Tuner | ||||
Valves / Tubes | 7: ECC85 EF89 ECH81 EF89 EM80 EABC80 EL84 | ||||
---|---|---|---|---|---|
Semiconductors (the count is only for transistors) | B250C100 |
Main principle | Superheterodyne (common); ZF/IF 460/10700 kHz |
---|---|
Tuned circuits | 6 AM circuit(s) 12 FM circuit(s) |
Wave bands | Broadcast, Long Wave, Short Wave plus FM or UHF. |
Details | |
Power type and voltage | Alternating Current supply (AC) / 110, 125, 150, 220, 240 Volt |
Loudspeaker | 3 Loudspeakers |
Power out | 6 W (unknown quality) |
from Radiomuseum.org | Model: TS2 Ch= RC61 - Braun; Frankfurt |
Material | Wooden case |
Shape | Tablemodel with Push Buttons. |
Dimensions (WHD) | 545 x 395 x 280 mm / 21.5 x 15.6 x 11 inch |
Notes | drehbare Ferritantenne. |
Net weight (2.2 lb = 1 kg) | 11.3 kg / 24 lb 14.2 oz (24.89 lb) |
Price in first year of sale | 320.00 DM |
Source of data | HdB d.Rdf-& Ferns-GrH 1956/57 / Radiokatalog Band 1, Ernst Erb |
Mentioned in | HdB d.Rdf-& Ferns-GrH 1957/58 |
All listed radios etc. from Braun; Frankfurt
Here you find 1042 models, 906 with images and 643 with schematics for wireless sets etc. In French: TSF for Télégraphie sans fil.
Hits: 2287 Replies: 4
Braun (Chassis) RC61; TS2 output transformer wiring
|
|
Marco Gilardetti
10.Mar.06 |
1
Gentlemen, I have an output transformer of the Braun RC61 as a spare part, and I'm planning to use it in a home made project. However, though I have the schematics, I'm having a hard time figuring out the wiring. I see three thicker cables coming out of the transformer. Plus, there are other four very thin cables of different colors, grouped in couple of two. Can some owner of the radio please check which cable goes where? I'm basically trying to use it as a simple output transformer: tube output on one side, a single 8 Ohm loudspeaker on the other. I would need four connections, but the transformer has seven. Any help would be highly appreciated. Thanks a lot. |
Arpad Roth † 27.3.17
10.Mar.06 |
2
E-mail adress is okay. |
Marco Gilardetti
10.Mar.06 |
3
Arpad, thanks a lot (I suppose your post went with my other thread, someone can move posts?). As a matter of fact, that's not the address Ake put on his website. Will sure give it a try. Cheers - M. |
Marco Gilardetti
23.Mar.06 |
4 Please note that the two last posts were off-topic, and the problem has not been solved yet. Will be very thankful to whoever will help! |
Andre Bryx
13.Apr.06 |
5
Hello Marco! I have an open Chassis here ready for shipping could took a quick look. If you have the shematics in front of you, the following is wired: Thick Black: Output for the Bass Speaker Thick Yellow: Output for the High Speakers over the 5uF capacitor Thick Brown: Output Ground Small Red: Goes to [+] of the rectifier Small Yellow: Goes to W55 / 1.5K Small Green: Goes to EL84 Anode / Pin 7 Small Black: Goes to W54 / 50K But without warranty, it depends only on my own RC61 model! Hope that helps.. Best regards, Andre |