|
|
||||
Año: 1956–1958 | Categoría: Radio - o Sintonizador pasado WW2 | ||||
Válvulas | 7: ECC85 EF89 ECH81 EF89 EM80 EABC80 EL84 | ||||
---|---|---|---|---|---|
Semiconductores (sólo se cuentan los transistores) | B250C100 |
Principio principal | Superheterodino en general; ZF/IF 460/10700 kHz |
---|---|
Número de circuitos sintonía | 6 Circuíto(s) AM 12 Circuíto(s) FM |
Gama de ondas | OM, OL, OC y FM |
Especialidades | |
Tensión de funcionamiento | Red: Corriente alterna (CA, Inglés = AC) / 110, 125, 150, 220, 240 Volt |
Altavoz | 3 Altavoces |
Potencia de salida | 6 W (unknown quality) |
de Radiomuseum.org | Modelo: TS2 Ch= RC61 - Braun; Frankfurt |
Material | Madera |
Forma | Sobremesa de botonera. |
Ancho, altura, profundidad | 545 x 395 x 280 mm / 21.5 x 15.6 x 11 inch |
Anotaciones | drehbare Ferritantenne. |
Peso neto | 11.3 kg / 24 lb 14.2 oz (24.89 lb) |
Precio durante el primer año | 320.00 DM |
Procedencia de los datos | HdB d.Rdf-& Ferns-GrH 1956/57 / Radiokatalog Band 1, Ernst Erb |
Mencionado en | HdB d.Rdf-& Ferns-GrH 1957/58 |
Ir al listado general de Braun; Frankfurt
Donde encontrará 1041 modelos, 905 con imágenes y 642 con esquemas.
Entradas: 2285 Réplicas: 4
Braun (Chassis) RC61; TS2 output transformer wiring
|
|
Marco Gilardetti
10.Mar.06 |
1
Gentlemen, I have an output transformer of the Braun RC61 as a spare part, and I'm planning to use it in a home made project. However, though I have the schematics, I'm having a hard time figuring out the wiring. I see three thicker cables coming out of the transformer. Plus, there are other four very thin cables of different colors, grouped in couple of two. Can some owner of the radio please check which cable goes where? I'm basically trying to use it as a simple output transformer: tube output on one side, a single 8 Ohm loudspeaker on the other. I would need four connections, but the transformer has seven. Any help would be highly appreciated. Thanks a lot. |
Arpad Roth † 27.3.17
10.Mar.06 |
2
E-mail adress is okay. |
Marco Gilardetti
10.Mar.06 |
3
Arpad, thanks a lot (I suppose your post went with my other thread, someone can move posts?). As a matter of fact, that's not the address Ake put on his website. Will sure give it a try. Cheers - M. |
Marco Gilardetti
23.Mar.06 |
4 Please note that the two last posts were off-topic, and the problem has not been solved yet. Will be very thankful to whoever will help! |
Andre Bryx
13.Apr.06 |
5
Hello Marco! I have an open Chassis here ready for shipping could took a quick look. If you have the shematics in front of you, the following is wired: Thick Black: Output for the Bass Speaker Thick Yellow: Output for the High Speakers over the 5uF capacitor Thick Brown: Output Ground Small Red: Goes to [+] of the rectifier Small Yellow: Goes to W55 / 1.5K Small Green: Goes to EL84 Anode / Pin 7 Small Black: Goes to W54 / 50K But without warranty, it depends only on my own RC61 model! Hope that helps.. Best regards, Andre |