Supra-Selector 37 SB4346GW
Körting-Radio; Leipzig, später Grassau
- Hersteller / Marke
- Körting-Radio; Leipzig, später Grassau
- Jahr
- 1936/1937
- Kategorie
- Rundfunkempfänger (Radio - oder Tuner nach WW2)
- Radiomuseum.org ID
- 2433
-
- anderer Name: Dietz & Ritter GmbH, Dr.
Klicken Sie auf den Schaltplanausschnitt, um diesen kostenlos als Dokument anzufordern.
- Anzahl Röhren
- 6
- Hauptprinzip
- Superhet allgemein; ZF/IF 468 kHz
- Anzahl Kreise
- 7 Kreis(e) AM
- Wellenbereiche
- Langwelle, Mittelwelle und zwei mal Kurzwelle.
- Betriebsart / Volt
- Allstromgerät / 110; 125; 150; 220; 240 Volt
- Lautsprecher
- Dynamischer LS, keine Erregerspule (permanentdynamisch)
- Material
- Gerät mit Holzgehäuse
- von Radiomuseum.org
- Modell: Supra-Selector 37 SB4346GW - Körting-Radio; Leipzig, später
- Form
- Tischgerät-gross, - Querformat (breiter als hoch oder quadratisch).
- Abmessungen (BHT)
- 490 x 404 x 305 mm / 19.3 x 15.9 x 12 inch
- Bemerkung
- variable Bandbreite. Abstimmanzeige durch Glimmröhre. Spartransformator!!.
- Nettogewicht
- 22 kg / 48 lb 7.3 oz (48.458 lb)
- Originalpreis
- 415.00 RM
- Datenherkunft
- HandB.d.d.Rundfunk-Handels 1936/37 / Radiokatalog Band 1, Ernst Erb
- Schaltungsnachweis
- Lange+Schenk+FS-Röhrenbestückung
- Weitere Modelle
-
Hier finden Sie 814 Modelle, davon 666 mit Bildern und 465 mit Schaltbildern.
Alle gelisteten Radios usw. von Körting-Radio; Leipzig, später Grassau
Sammlungen
Das Modell Supra-Selector 37 befindet sich in den Sammlungen folgender Mitglieder.
Forumsbeiträge zum Modell: Körting-Radio;: Supra-Selector 37 SB4346GW
Threads: 1 | Posts: 4
I am having difficulty getting the 6 MHz coil slug adjusted for the K1 SW band. 12 MHz trimmer cap adjusts just fine. But the 6 MHz slug can be pulled out of the coil but the oscillator is still running too low. I have cleaned this coil of all dirt and contaminants.
Are theses coil forms or wire insulation subject to deterioration? I have disassembled and cleaned the Oscillator section and switches a few times. Insured there were no visible damages to the oscillator coil. I changed the oscillator 50 pf (was 62pf) grid capacitor and the G2 to cathode 500pf (was 637 pf) capacitor.
I even tried to align the SW at 12 MHz minus IF but the trimmers did not cover that range.
I am open to any suggestion.
Paul E. Pinyot † 2013, 10.May.12