Supra-Selector 37 SB4346GW
Körting-Radio; Leipzig, später Grassau
- Pays
- Allemagne
- Fabricant / Marque
- Körting-Radio; Leipzig, später Grassau
- Année
- 1936/1937
- Catégorie
- Radio - ou tuner d'après la guerre 1939-45
- Radiomuseum.org ID
- 2433
-
- alternative name: Dietz & Ritter GmbH, Dr.
Cliquez sur la vignette du schéma pour le demander en tant que document gratuit.
- No. de tubes
- 6
- Principe général
- Super hétérodyne (en général); FI/IF 468 kHz
- Circuits accordés
- 7 Circuits MA (AM)
- Gammes d'ondes
- PO, GO et 2 x OC
- Tension / type courant
- Appareil tous courants (CA / CC) / 110; 125; 150; 220; 240 Volt
- Haut-parleur
- HP dynamique à aimant permanent + bobine mobile
- Matière
- Boitier en bois
- De Radiomuseum.org
- Modèle: Supra-Selector 37 SB4346GW - Körting-Radio; Leipzig, später
- Forme
- Modèle de table profil bas (grand modèle).
- Dimensions (LHP)
- 490 x 404 x 305 mm / 19.3 x 15.9 x 12 inch
- Remarques
- variable Bandbreite. Abstimmanzeige durch Glimmröhre. Spartransformator!!.
- Poids net
- 22 kg / 48 lb 7.3 oz (48.458 lb)
- Prix de mise sur le marché
- 415.00 RM
- Source
- HandB.d.d.Rundfunk-Handels 1936/37 / Radiokatalog Band 1, Ernst Erb
- Source du schéma
- Lange+Schenk+FS-Röhrenbestückung
- D'autres Modèles
-
Vous pourrez trouver sous ce lien 820 modèles d'appareils, 672 avec des images et 473 avec des schémas.
Tous les appareils de Körting-Radio; Leipzig, später Grassau
Collections
Le modèle Supra-Selector 37 fait partie des collections des membres suivants.
Contributions du forum pour ce modèle: Körting-Radio;: Supra-Selector 37 SB4346GW
Discussions: 1 | Publications: 4
I am having difficulty getting the 6 MHz coil slug adjusted for the K1 SW band. 12 MHz trimmer cap adjusts just fine. But the 6 MHz slug can be pulled out of the coil but the oscillator is still running too low. I have cleaned this coil of all dirt and contaminants.
Are theses coil forms or wire insulation subject to deterioration? I have disassembled and cleaned the Oscillator section and switches a few times. Insured there were no visible damages to the oscillator coil. I changed the oscillator 50 pf (was 62pf) grid capacitor and the G2 to cathode 500pf (was 637 pf) capacitor.
I even tried to align the SW at 12 MHz minus IF but the trimmers did not cover that range.
I am open to any suggestion.
Paul E. Pinyot † 2013, 10.May.12